Take to dealer and get a service!
Or a "scan tool" may allow you to clear it using the diagnostic port.
Though finding one that suits a Auston martin db9 may be hard
All newer models of Aston Martin cars the body parts are made of Carbon Fibre and Titanium, due to its light weight
you don't you buy a better car e.g. Aston martin. There are 3 screws you have to take out first, on Fords they are hidden.
Both DCi and DXi Renault HGV vehicles the service reset is a manual procedure using the dashboard instruments.
aston villa play in SH1T & BLUE
Lightish blue :)
If it is the check engine light it has nothing to do with an oil change. If it service required in th eoverhead console you press the "step" button until it says "0" miles to service. Then press and hold "reset" until it resets.
St. Martin Island Light was created in 1905.
No
what is light up procedure of afbc boiler
I used this procedure to reset my 2002 s40 services light (it should work for 2008 s40 also). a) insert ignition key and turn it to the 1st click - no lights on bottom of the instrument panel should be light up b) press and hold trip odometer reset button, and turn the ignition key to the 2nd click - the row of lights at the bottom of the instrument panel should come on c) after about 5 secs the lights should go off except the Service reset light - it will blink d) when the Service reset light has blinked for about 3 times - release the odometer reset button e) the Service reset is complete Note: This procedure cannot be used to reset Check Engine light - it requires an OBD2 code reader.
you close the door. wait for the dome light to shut off. then turn the key on push the "o" button twice. themn turn off the key. then push and hold the "o" button while turning the key back on. keep holding the button for about ten seconds and then it will beep and reset the service light.
The procedure will vary from year to year to bypass the service ride control, but the basics are the same. Put the unit into program mode (look in your owners manual.) Set the default to 0. With the default of 0 the light should stay off.