0
For a 1988 Nissan Pulsar N13, the ignition timing is typically set at 15 degrees before top dead center (BTDC) at idle with the engine fully warmed up. It's important to ensure that the vacuum advance is disconnected and the engine is idling at the correct RPM, usually around 800-900 RPM. Always refer to the vehicle's service manual for specific details and adjustments, as variations may exist based on engine type and regional specifications.
What else can I help you with?
How do you do ignition timing on 1988 Toyota Corolla fx?
how to do ignition timing on 1988 Toyota corolla fx
What is the Ignition timing for 1988 Chevy 454 engine?
what is the ignition timing for a 1988 Chevy 454 engine
What is the timing setting on a 1988 f-150 with a straight six?
www.motorcraft.com shows the ignition timing setting , for a 1988 F-150 4.9 L ( 300 cubic inch ) straight 6 cylinder engine as 10 degrees BTDC
How do you set timing on a 1988 DOHC 16v scirocco?
Ignition timing or valve timing?
What is the timing setting for a 1988 Toyota Tercel?
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
What is the correct ignition timing for a 1988 mustang 5.0L?
10 degrees BTDC
What is timing set at on 1988 5.0?
I have a 1990 and factory setting for base timing is 10 degrees, I believe.
What is timing for a 1988 Mazda 626?
The ignition timing for a 1988 Mazda 626 typically ranges between 8 to 12 degrees BTDC (Before Top Dead Center) at idle, depending on the specific engine and emissions requirements. It's essential to check the vehicle's service manual for the exact specifications for your engine variant. Proper timing ensures optimal engine performance and efficiency, so adjustments should be made carefully. Always use a timing light for accurate measurement when setting the ignition timing.
How do you set the timing on an 1988 Chevy Celebrity?
The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.
What is the correct procedure for checking the ignition timing in 1988 V6 Fiero?
You will need a timing light, set it at 10 degrees BTD
Where is the ignition timing supposed to be set on a 1988 Chevrolet pick up with a 350?
0 degrees
What is the Ignition timing degree for 1988 ford ranger 2.9 Liter?
10 degrees BTD
