0
What else can I help you with?
How do you calculate the length of injection molding zones?
Runners and Gates are determined by the design of the part being molded and the size of the injection molded machine and is best left to molder's tool maker to determine and usually fine tune during the first run of parts
What is relation of shot capacity and shot weight in plastics injection molding?
Shot Capacity : The maximum weight of molten resin that the injection molding machine can push out with one forward stroke of the screw during injection molding operation. Shot weight : The weight of the material injected into the mold in a single shot by an injection molding machine. (Weight of the molded part(s) + Weight of the runner + gate and the sprue)
How much pressure should be used in injection moldingHow many parts can an injection mold make?
The amount of pressure used in injection molding is a critical factor in the success of the molding process. Too little pressure can result in poor-quality parts with defects, such as incomplete filling of the mold cavities or inadequate bonding between the plastic and the mold. Too much nozzle pressure can cause damage to the mold and the injection molding machine, as well as excessive wear and tear on the equipment. The amount of pressure used in injection molding is determined by several factors, including： a. The type and viscosity of the plastic material. b. The size and shape of the part being molded. c. The design and construction of the mold. d. The injection molding machine. e. The complexity of the part being molded. In general, the pressure used in injection molding should be sufficient to fill the mold cavities and create a strong bond between the plastic and the mold.
Where is the location for the idle control valve on a 1999 Ford Expedition 5.4?
The idle control valve on a1999 Ford Expedition is on the upper part of the engine by the throttle body and fuel injection.
Injection mold with movable molded parts?
Due to some special structures of plastic parts, the injection mold is required to be equipped with movable molding parts, such as movable punches, movable dies, movable inserts, movable threaded cores or rings, etc., which can be combined with the plastic parts during demoulding. Move out of the mold together, and then separate from the plastic part.
What part is not shared by both throttle body injection and a carburater?
Which part is not shared by both throttle body injection and a carburetor ?
What is a tire cord?
It is a part of the fabric inside the tread that is set in rubber when the tire is molded.
Can you cut off the molded part of the orange and eat the rest without any problems?
Yes, you can.
Can you cut off the molded part of the strawbrry and eat the rest without any problems?
yes
Will molded jerky hurt you?
It certainly can, but that depends upon what kind of mold is present. You should never consume moldy food, or even a non-molded part of something that is partially moldy. When in doubt, throw it out.
Why is it important to try out the mold before mass production?
Before a new mold is injection molded or when the machine is replaced by another mold for production, mold trial is an essential part. The good or bad results of the mold trial will directly affect the smoothness of the subsequent production in the factory. Therefore, it is necessary to follow reasonable operation steps and record the useful technical parameters during the injection molds trial for the mass production of products.
Just got some new boots how do you shift gears do you use the metal tip on the end?
The metal tip on the end of your boots is for protection. You shift just the same as wearing any other shoe, on the upper part of foot. Most boots have some type of an injection molded shift protector on top of the boot.
