A dedicated outlet is a single circuit from a single or double pole breaker to a specific outlet or receptacle for a single specific device or appliance. An example of this would be a circuit for a refrigerator, microwave, dryer, range, etc..This is typically referred to as a "dedicated circuit". A dedicated circuit usually is supplying power to only one or perhaps two receptacles, such as a computer station. An example in your home under current code is your washing machine is required to be on a dedicated circuit. Dedicated receptacle circuits may be either 15 or 20 amp.A dedicated circuit is just what it sounds like. I'ts a circuit dedicated to one particular device. Most receptacle (you may call them outlet's) circuits will power several outlets. A dedicated circuit will power only one specific outlet or appliance. Some examples would be a refrigerator, a garbage disposal, or a microwave.
A "dedicated" circuit is one to which only one device is or can be connected; therefore the circuit is "dedicated" to the device. A NON dedicated circuit will therefore be one to which multiple devices can connect, such as the wall outlets in your home. Multiple wall outlets are connected to a common circuit breaker, making that an example of a non-dedicated circuit.
A 15 amp dedicated circuit breaker should be used for the dishwasher. The disposal can be wired to the general kitchen 15 amp circuit.
Just use one of the hot wires and cap the other. Since you are changing the breaker, the unused line will not be hooked to anything. There is really nothing to be gained by pulling new wire.
A 2C #14 will be suffice but it should be the only device on the circuit. This is known as a dedicated circuit.
A dedicated circuit.
A "dedicated" circuit is one to which only one device is or can be connected; therefore the circuit is "dedicated" to the device. A NON dedicated circuit will therefore be one to which multiple devices can connect, such as the wall outlets in your home. Multiple wall outlets are connected to a common circuit breaker, making that an example of a non-dedicated circuit.
Not in the latest edition of the code book. It should be on a 15 amp dedicated circuit.
No
Resistors are tiny devices on circuit boards. Prices should range but should not be expensive but dependent on the materials used and the nature of conductivity.
The circuit range should be between 3.4 and 4.5. Anything above 5 or below 3 is not performing correctly.
Yes.