Yes.
You need to check coolant temperature sensor and the water pump.
Radiator coolant.
You should use three liters of coolant in the Camry. If there is still room to add more fluid, then add water.
Water should be fine, but mix it with coolant when you can to prevent rust from developing in the radiator.
The 1994 Toyota Camry typically has two radiator hoses: the upper radiator hose and the lower radiator hose. The upper hose connects the radiator to the engine's thermostat housing, while the lower hose connects the radiator to the water pump. These hoses are crucial for the vehicle's cooling system, allowing coolant to circulate.
Never put just straight water in your motor. You want to top off your radiator first then top off your coolant in the reservoir. Water will rust your motor from the inside out.
Connected to the upper radiator hose. Coolant flows from the engine to the radiator to be cooled. The coolant temp. sensor should be screwed into it.
To flush a radiator, first make sure the engine is off and cool. Locate the radiator drain plug, usually at the bottom, and use a container to catch the old coolant. Pour radiator flush solution and water into the radiator, run the engine for a few minutes, then drain the radiator by opening the drain plug. Finally, refill the radiator with the recommended coolant and water mixture.
Water alone is not used as coolant for automobiles.
Yo should always run a 50-50 mix of coolant and water.
coolant
1 gallon of LONG LIFE coolant (red in color) plus 1 gallon of distilled water, if 2003 or before; and for 2004 and newer use 2 gallons of SUPER LONG LIFE coolant (it's pink in color and pre-mixed) PLEASE DO NOT USE TAP WATER!