0
Should the front end be aligned after replacing the lower control arms on a 2002 Hyundai Elantra?
Kckatty
Whenever you get anything that has to do with the front suspension replaced you should go get your car realigned It is just good to make sure that you have it aligned.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you reprogram a remote control for a Hyundai elantra 2002?
It has to be by a dealer.
How do you change the climate control on a 2008 Hyundai Elantra?
read the manaul
What does a PO443 code mean in a 2001 Hyundai Elantra?
P0443, EVAP System Purge Control Circuit Malfunction. P0444
2001 Hyundai elantra trouble code 2300 what is that mean?
Trouble code P2300 means: Ignition Coil "A" Primary Control Circuit Low
Where is the idle sensor located on a 2002 Hyundai Elantra GLS?
The Idle Speed Control actuator is located right behind the air intake plenum
Where is the purge control valve located on a 2000 Hyundai elantra?
attached to the rubber line that runs off the intake manifold. It should be near the brake booster.
Is it necessary yo have wheels aligned after replacing an upper control assembly?
It would be recommended for most vehicles especially if you disturbed any adjustments or shims.
What could cause a Hyundai Elantra after it was in an accident for the engine to rev up by itself to 3000 rpm and then down at all times?
its probably your TPS Switch or your idle control sensor, check engine light will not come on for either take to Hyundai dealership
Where is the idle air control motor on a 98 Hyundai elantra?
mounted on the metal intake near the firewall. should be two large hoses. one from the the rubber intake to the ICV (idle control valve) and one from the ICV to the metal intake. hope this helps
What causes a 2002 Hyundai Elantra Evaporative emission Control system leak detected gross leak?
The first thing to check is the gas cap to see if it is on tight and the gasket is in good condition. After that, it gets tricky.
How do you disassemble the control dashboard on a 1999 Hyundai Elantra to be able to clean the contacts on the fan speed control knob?
Try this http://www.hmaservice.com/webtech/iindex.asp?id=10119&modelyr=1999&modelid=5&enginemotormmc=0&pre=0&reviewed=1#_10119
What would cause my 04 Hyundai Elantra to stall or jerk while driving or rev up to as high as 4000 rpms while stopped?
a bad idle sensor control valve to start with or your egr valve has a vaccum leak
