Emergency Heat [EM] should only be used as a backup if the heat pump fails. EM heat uses 1.5 to 3 times as much or electricity as the heat pump.
A heat pump thermostat.
Only if the outside unit is a heat pump.
i set my thermostat to cool, my heat pump start it go to heat but not cool, i think the thermostat. can u help.
A programmable thermostat works fine with a heat pump. Just remember that a heat pump does not heat as fast as a furnace because of the lower BTU ratings so do not set the thermostat as far back as you normally would. Also make sure to buy a thermostat that has heat pump terminals.
The purpose of a thermostat on a running heat pump is to be able to determine the temperature the pump is operating at. This is used for regulating the heats needed.
During an emergency. i.e. when the heat pump is not working. If your heat pump can not keep your house warm, then the auxiliary heating coils (same thing as emergency heat) will come on automatically. If not, then there is a problem with your heating system.
On a system that uses a Heat pump, the heat setting utilizes the pump, and electrical coil heating as a backup. On the EM setting the heat pump won't run, only the axillary coils will provide heat.
First, is the thermostat in he correct position for cooling? Is there a red light glowing on the thermostat? There could have been a power surge or outage and the heat pump needs to reset. Turn the power off to the heat pump at the control panel for a couple or minutes then back on again to reset the heat pump.
Any brand or make will work if it is 2 heat 1 cool thermostat
yes it can but everytime you want heat you have to put it on Emergency Heat..
Usually a backup heating unit. For instance in a heat pump when the temperature drops below the temperature where the heat pump cannot extract heat from the existing air electric heating elements kick in.
when running the heat-pump the air blowing from the heat ducts is not hot ( it's to cold for the heat-pump). you have a main furnace and it won't turn on ( is thermostat selected for this source), ( is the power switch for main furnace on ), ( is fuse for this furnace good). If these are good (check thermostat wiring at thermostat, and transformer).