anti clock wise if you want to unscrew the moon
The competitors will run anti-clockwise around the track.
You fit the jaws onto an appropriate nut or bolt and turn it - clockwise to tighten, anti-clockwise to loosen.
For a basic outline on how to use a screw extractor, you just basically punch the screw before drilling and make a small hole in the center of the screw. Insert the extract and rotate counter-clockwise until the screw is free. For more detailed information, visit http://www.wikihow.com/Use-a-Screw-Extractor
You can drill it and use an easy out. If it is a big screw I have used a punch and hammer to drive the screw loose by hitting it on the far side in a counter clockwise direction.
The best way to tighten a loose shower handle screw is to use a screwdriver to turn the screw clockwise until it is securely fastened.
Anti clockwise is used in the winter to bring heat down to the room. during the summer you would use the clockwise motion
To replace the belt tensioner on a v6 commodore you start by removing the fan belt by using a 18mm spanner and rotating the pulley assembly anti clockwise. Undo the bolt by holding the tensioner pulley on and use the 18mm spanner to turn bolt clockwise to undo threaded. Place new pulley onto shaft, drop some Loctite onto bolt and screw in. Rotate pulley anti clockwise and put the fan belt back in.
it will screw out if you gently use vise grips and remove as normal threads do, counter clockwise
Use the proper type screw driver to match the screw heads and turn counter clockwise. For you digital people out there that do not have a watch with hands, the top of the screw head turns left.
To use an Allen wrench, insert the long end into the screw or bolt head and turn it clockwise to tighten or counterclockwise to loosen. Make sure the wrench is fully inserted to avoid stripping the screw.
For a 6 screw, you should use a drill bit that is 7/64 inches in size.
To properly screw a screw into wood, first choose the correct size and type of screw for the job. Use a screwdriver or power drill to slowly insert the screw into the wood, making sure it is straight and not at an angle. Apply firm pressure while turning the screw clockwise until it is securely fastened in the wood. Be careful not to overtighten the screw, as this can damage the wood.