answersLogoWhite

0

You should be able to do this just by looking at them. They'll start at the windshield washer fluid pump (located at the bottom of the reservoir), come up along the firewall, and terminate at the sprayers.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you reset the low windshield washer fluid light in a 2001 Tahoe when its full?

Should reset when fluid added--may be defective sensor in reservoir


Washer fluid level sensor 2001 villager?

The 2001 Villager washer fluid level sensor is inside of the washer fluid reservoir. The sensor can be access through the bottom of the washer fluid reservoir.


Where is the rear windshield washer fluid on a 2001 exterra?

It also uses your front windshield washer fluid conatiner


How do you remove the windshield washer fluid tank from a Chevrolet cavalier 2001?

You can remove the windshield washer fluid tank from your 2001 Chevy Cavalier by removing the retaining bolts. There will be for retaining bolts at the bottom of the windshield washer fluid tank.


Where do you add blinker fluid on A 2001 Tahoe 5.3?

Cdkajsba


What color is transmission fluid in a 2001 Chevy Tahoe?

Red.


Where do you add transmissin fluid on a 2001 Tahoe?

Same place you check the fluid level.


How do you fill the rear window washer fluid on a 2001 Xterra?

It is pumped in from the front washer reservoir.


Where is the windshield washer pump on a 2001 jeep Cherokee?

it is generally on the bottom of the washer fluid reservoir


Where is the wiper washer pump motor located on a 2001 Dodge Caravan?

bottom of the washer fluid bottle


How many quarts of trans fluid do you put once you drain in a 2001 Chevy Tahoe 5.3L?

You only needd 5 quart for Chevy Tahoe 2001.


How do you change out a washer fluid reservoir on a 01 Malibu?

To change the washer fluid reservoir on a 2001 Malibu, first, ensure the vehicle is turned off and the keys are removed. Remove any necessary panels or covers to access the reservoir, then disconnect the fluid lines and electrical connectors. Unscrew the mounting bolts or clips holding the reservoir in place, and carefully lift it out. Install the new reservoir by reversing the steps: secure it with bolts, reconnect the lines and electrical connectors, and refill it with washer fluid.