answersLogoWhite

0

If they are real 'side cutters' then they have flat jaws for gripping, and a wire cutter on one side. You don't see these around much any more. People have taken to calling 'diagonal wire cutters' , side cutters now.

User Avatar

Aylin Schulist

Lvl 10
3y ago

What else can I help you with?

Related Questions

What is side cutter?

A pair of pliers for cutting wire.


How do you care side cutter pliers?

Keep the pliers cleansuitably lubricatedKeep the cutting edges sharp


What is the function of side cutter plier?

Side cutters are pliers i haven't seen in the stores for a while. They had flat jaws and a small wire cutter on one side. A few of them were constructed so the jaws remained parallel. I have one pair dating from 1942 when they were made originally for the USAAF.


Side-cutters or Diagonal cutting pliers should be used to cut?

Side-cutters or diagonal cutting pliers should be used to cut wires, cables, and other materials where precision cuts are required. They have a cutting edge that is angled to provide a clean cut close to the surface.


What is the function of side cutting plier?

Side cutting pliers are used in electronics, to clip off the wires of components once they have been soldered on to a board, without risking too much cutting into the solder.


What are diagonal cutting pliers?

Diagonal pliers (alos called wire cutters or diagonal-cutting pliers) are pliers intended for the cutting of wire (they are generally not used to grab or turn anything). They are sometimes called side cutting pliers or side cutters, although these terms are shared by other pliers designs, such as lineman's pliers, and may lead to confusion. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a diagonal", hence the name. Instead of using a shearing action as with scissors, they cut by indenting and wedging the wire apart. The jaw edges are ground to a symmetrical "V" shape; thus the two jaws can be visualized to form the letter "X", as seen end-on when fully occluded. The pliers are made of tempered steel and inductive heating and quenching are often used to selectively harden the jaws.


An electricians side cutting pliers could properly be used to?

If they are real 'side cutters' then they have flat jaws for gripping, and a wire cutter on one side. You don't see these around much any more. People have taken to calling 'diagonal wire cutters' , side cutters now.


How do you care for side cutting pliers?

Keep them dry and occasionally put a drop of oil between the sides at the pivot point.


What is the other word used for side cutting pliers?

Wire cutter. It's two words as wirecutter may not be in the dictionary.


What are the different kinds of pliers?

There are electricians straight pliers, wiring pliers, long nose pliers, angled long nose pliers, side cutting pliers, parallel jaw pliers, locking pliers, aircraft twist locking pliers, channel lock pliers, oil wrench pliers, water pump pliers and fencing pliers. -I have each of these and I'm sure there are many more kinds.


How to you cut a hanger?

Assuming you have a standard wire coat hanger, you can either use a hacksaw or a pair of sturdy side-cutting pliers. Some ordinary pliers have little recesses near the jaw that can also be used but they tend not to make clean cuts.


Is there such thing as a side cut pliers?

Yes, they are called side cutters, dykes, snips, etc. They are actually not pliers though.