answersLogoWhite

0

bit means a signal that goes around every where.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Will an HDMI cable hold it's signal over 10 yards?

For an HDMI cable 10 yards is the maximum supported length, so it should probably hold it's signal. It would help to buy good quality cable, just to make sure.


How do you Write it past passive form-set the amplitude of the input signal 10 volt peak to peak and the frequency at 1khz?

the amlitude of the input signal 10 volt peak to peak was set at 10 khz


When was No Signal created?

No Signal was created on 2001-10-09.


When was Loss of Signal created?

Loss of Signal was created on 2006-10-03.


What is the time for the TV signal to come from the TV mast to your TV set?

The signal will move down the cable at from about 1/3 the speed of light to about 9/10 the speed of light, depending on the type of cable used. If there is a booster amplifier in the cable between the antenna and the TV set this will add more delay. You will need to know the length and types of cable used (and look up their signal propagation speed) as well as the delay of your booster amplifier if your system has one to calculate the answer to your question.


What is the signal to noise ratio formula in dB?

The signal-to-noise ratio (SNR) formula in decibels (dB) is calculated as 10 times the logarithm base 10 of the ratio of the signal power to the noise power. The formula is: SNR(dB) 10 log10(signal power / noise power).


When a signal of 10 mV at 75 MHz is to be measured then what instrument can be used?

When a signal of 10 mV at 75 MHz is to be measured then which of the following instrument can be used


When a signal of 10 mV at 75 MHz is to be measured then which of the instruments can be used?

When a signal of 10 mV at 75 MHz is to be measured then which of the following instrument can be used -


What are the Memphis Tennessee police radio 10 codes?

We don't use codes unlike other departments. Memphis just says what it is. We only have a few codes like signal 10 is has signal 12 is out in foot signal q is silent


What is Educational Bureau for Adverse Weather?

It talks about the arrangements of classes and transportation services by typhoons and rainstorms. Classes and transportation services resumes as usual during: Amber Rainstorm Warning Signal Red Rainstorm Warning Signal Standby Signal No. 1 Strong Wind Signal No. 3 Classes and transportation services suspends during: Black Rainstorm Warning Signal No. 8 Gale or Storm Signal Increasing Gale or Storm Signal No. 9 Hurricane Signal No. 10


What channel is NBC in Sussex County Delaware?

Wmgm channel 40 in Wildwood New Jersey has a signal that reaches southern Delaware. On cable its channel 10 from Philadelphia.


What devices uses anolog signals?

Generally process control devices use analog signal. Normally in an industrial automation setup, 0-20 mA (mili amp) or 4-20 mA or 0- 10 Volts are used. These signals are used for both providing control output and to provide feed back signal (say to a PLC (programmable logic controller) or DCS) Example for a control out put is a motorized damper operated by 4 - 20 mA signal. PLC provides 4-20 ma signal. Example of a feed back signal is 4 - 20 mA signal from temperature transmitter, measuring a liquid temperature to PLC as input.