0
What else can I help you with?
Can you run while eating a sub?
it depends what kind of sub it is
Who was the nZer to run the first sub minute mile?
Nobody has run a sub-minute mile. Nobody is anywhere near that!
What does run out sub mean?
It means that the player was run out by the substitute fielder.
What is a good 5km run time?
Sub 20 for a Man and sub 25mins for a girl is a good time.
Who has run the most sub-4-minute miles?
American Steve Scott has run the most sub-4-minute miles. He achieved this feat 136 times.
When was the sub four-minute mile run?
The first sub four minute mile was run May 6, 1954 by Roger Bannister of Great Britain in Oxford, England.
Who has run the most sub 4 minute miles?
Johnny Walker
Does it matter if you have a Jensen radio when trying to run a sub and amp?
No it does not matter.
Which command is used to create a sub processes?
For Unix, any command is run as a sub-process. You don't need an actual command to create the subprocess. You can also force the process to run in the background by appending a '&' symbol at the end of the command.
Can you hook both a subwoofer and speakers to 1 amp If so do I need to buy a amp that's even more powerful Then what the sub requires?
You can connect a sub and speakers to one amp, depending on how many channels your amp has. A 4 channel amp will be able to run one (or two) subs using two channels (one bridged* sub or two subs) and two speakers running one channel each. A 2 channel amp will run 2 speakers or one bridged sub. A 6 channel amp will run one bridged sub (or two subs), 2 front speakers and 2 rear speakers. In my opinion, you will get the most performance, depending on which amps you use, by using a monoblock amp for your sub and an amp with enough channels to run all of your speakers. # Bridged = putting together the power of two channels to run one sub or speaker. Note: not all amps are bridgeable.
Correct way to hook up pioneer 12Ins sub woofer's champion series?
Depends if it is dual 4Ohm or dual 2Ohm and what Impedance your Amp supports. *If you amp can handle 1Ohm Load and you have a dual 2Ohm sub you can run the sub in parallel to get a 1Ohm load (parallel meaning both + are connected with each and same with both -) *If your amp can handle 2Ohm load and you have a dual 4Ohm sub you can run the sub in parallel to get a 2Ohm load. *If your amp supports a 4Ohm load and you have a dual 2Ohm sub you can run the sub in series to get a 4Ohm load. (series meaning the - from one coil is to be connected with the + on the other coil) Do not mix up Impedance's make sure you find out what your Subs Impedance is and what you Amps Impedance is
Bridge two subs to a four channel amp?
If you amp is bridgeable you run + sub wire to ch 1 + then the -sub wire to the - of ch 2 of the amp. The same with the other sub + ch3 - ch4 that's how to bridge your amp.
