Want this question answered?
as with any starter motor just look for the gearbox and it will always be connected somewhere to that.
If it is a manual, the speedo cable is how you check the oil level. Remove the 10mm headed bolt holding the speedo cable in, twist and remove the cable and the oil level should be half way up the gear. If it is an auto, it will be a black dipstick which is easy to find, just look harder.
i think that speedo briefs are ok when you look at the facts. Think about it you don't see people complaning when a women wear a bikini
Look in the e38 forum and it will give you a detailed account of how to do itType your answer here...
look at your belts. the pully between your motor and the altenator. This is your water pump pully. The back end of the unit should be attached to your motor block.
sorry for my bad english, 1. see after that the largest cabel to the starter, dont is conected (shortcutted) to the smaller rellay innput ( 15) on the starter rellay. if the cabel is fix it. The onley way a starter could run is if it gets + on 30 and 15 at the same time, so look after the two cabels and look for shortcutting.
under the pass. side of motor if you look thru pass. side wheel well you can see it.
passenger side open the hood look right below the air cleaner intake tube i beleve its down there.
*Because "Speedo" and other similar swimwear can be very tight and constricting, the major factor is comfort. Depending on the stretch, ill-fitting swimwear can cause pain or even minor injury. ANSWERS : * I do is put it on, then I put a drag suit over it until my race begins. * Very carefully. * To attract girls, wear it even if your race hasn't started. (You will look bigger and sexier, but this depends on what size speedo you wear.)
old bald guys that think they look good in a speedo
it looks like what its suppose to look like a plain motor.
If you press the switch and hear the motor running, the the gear kit needs to be replaced. If you do not hear it, look at the dome light and see if it dims when you press the switch. If it does then you have a bad motor.