For a 1991 Chevy Lumina APV, the starting position on the distributor cap is typically at the terminal marked for cylinder number one, which is usually located at the front of the engine. To ensure correct firing order, the ignition wires should be connected in the correct sequence, following the firing order of 1-2-3-4-5-6. Make sure the rotor is pointing to the cylinder one terminal when aligning the distributor. Always consult the vehicle's service manual for specific details and diagrams.
There is no distributor cap as there is no distributor. There are 3 coil packs, each coil fires 2 spark plugs simultaneously.
Get a shop manual. There is no distributor. These have coil packs.
A 92 doesnt have a distributor just coil packs
there is none just coil packs
I think the module is in the distributor with two phillips screws
To deactivate the anti-theft system on a Chevy Lumina, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes or until the security light turns off. Afterward, turn the key to the "Off" position and then attempt to start the vehicle. If issues persist, consult the owner's manual or a professional mechanic for assistance.
The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.
In the rear of the distributor.
10 degrees advance
In the distributor.
Lexus Chevy Lumina Lorado Lincoln Continental
Chevy Lumina has not the carborator.