0
For new construction, mine are:
Switches; and basement; garage; utility; refer; freezer; & kitchen counter receptacles: 48" TTT
Bath receptacles: 44" TTT
Wahser; dryer; & gas range receptacles: 36" TTT
Most general use receptalces: 16" TTT
Furnace kill switch; thermostats: 60" TTT
TTT= To The Top
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Standard height of light switch?
Standard is 48" to the top of the switch box.
What is the pec requirement regarding the standard height for switches?
The standard height they are placed is no more than 48" above the floor. I mount my switch boxes with the top of the box 48" above the floor. You can install them lower if you wish but no lower than 15" above the floor.
What is the mailbox height from the ground to the center of the box?
42 inches from ground to bottom of the mail box.
Which switch is the blinker switch in a 1998 Ford Taurus?
The blinker switch is located to the left of the steering column. It is bolted up behind the dash board. It is not with the fuse box.
What is the height of a ford e350 box truck?
with the roof vent cover - - -mine is almost 9' hi
What is the correct mounting height of a bluebird box?
You want the bluebird box to be at least 5' in the air.
Standard height of light switch?
Standard is 48" to the top of the switch box.
WHAT IS THE STANDARD HEIGHT FOR SWITCH?
For a light switch in the home four foot to centre is a reasonable height. Some contractors set the outlet box at four foot to the bottom of the outlet box and other contractors set the box to four foot to the top of the outlet box. There is no code rule that stipulates the exact height that the outlet box must be set to.
Is mounting a 96 fiberglass cb antenna on an aluminum tool box a good idea?
As long as its a stable and secure mount, and installed correctly, and of course height restrictions observed, yes, that will work.
How do you remove tail light box in jeep wrangler?
Remove the lens, and the mounting screws are at the back of the box.
How is the electrical distribution box installed onto the stand?
mounting bolts
Why would an automatic transmission jerk into second gear and make a hissing noise when the gear is changing at higher speeds?
Check the mounting of the gear box, because the mounting of the gear box is like shock absorb.
How do you replace the head light switch on a 1994 Mercury Topaz?
First of all if all your lights don't work then its your switch I was told on my 94 it was the switch when my tail lights wouldn't work but all my other lights did. if that's your case or vise versa then its a bad ground somewhere. If not there is some mounting hardware under the dash almost where your fuse box is.
What height do you fit electric sockets in UK?
The standard height is around 12" to 15" the bottom of the box above the floor but for the disabled you can install them higher but no more than 48" above the floor. Pick a height that will work for the disabled and install all of them the exact same height.
How do you find the cubic inches in a box that is not square?
If it is a rectangular box, then volume = length*breadth*height, where each is measured in inches. If it is a cylindrical box, then pi*radius2*height, where the radius and height are measured in inches.
Can you be Mario to beat tox box switch star?
You can, but you need Wario to break the black box to reveal the switch.
What is special about a box spring with a low profile?
It's good to get a box spring that comes with the mattress which is matched to work perfectly together.
