Check the owners manual. In some models, a procedure must be done to remove the message. Example: in 2007 Chevy and up models, you must turn the key to the 'on' position (do not start the engine), and press the gas pedal to the floor 3 times to remove the "Change Oil" message.
you most likely have to change the front hubs with the speed sensors i have tried everything else
twist and pull out
Write the date and mileage on a small sticker and cover the light with it.
Turn the key to the on position,depress the accelerator pedal to the floor within 3 seconds. Wait and the light will flash and then go out. Turn the key off and then start the car. The light will come on monentarily and then go out.
Can be improper level.
the light bulb has changed our lives because with out it the world would be dull
On my 98 Tahoe under the bumper behind the are where the tag is located you just pull the light assembly out. It has a little pressure clip. replace light and replace assembly the same way.
You take it out. Then you put a new one in. Elementary, dear Watson.
How do you replace a break light switch on 1995 Chevy Tahoe
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.
you have to reset the computer
when the pencil enters the water