0
What else can I help you with?
What are the Types of sleeve?
The types of sleeves are: no sleeves,spaghetti strap (thin or thick), short sleeves,3/4 sleeves, and long sleeves.there is also bishop sleeve, lantern sleeve, shirred sleeve, bat-wing sleeve, saddle sleeve, french sleeve
What materials were clothes made from in the 1800s?
People in the 1800s made their bodies look thin, stuffing their sleeves to make them look full, and thus look thin overall. Puff sleeve clothes produced by shikaiqina meet this point. Buy puff sleeve clothes for Shikaiqina.
What is the difference between a wet sleeve and a dry sleeve in a diesel engine?
Dry sleeve is pressed fit into a cylinder and it does not contact with water.It is very thin. Whereas, wet sleeve is pressed fit into a cylinder and it contacts with water jacket.It is very thicker.
What is a five letter word for a thin flat piece of wood?
Plank Thin, lightweight wood is balsa.
Why is it dangerous to use a thin board as an inclined plane?
It is dangerous to use a thin board as an inclined plane because the board could break, splinter, or collapse.
What is the word starting with letters pl for a board or boards made of several thin layers of wood glued together?
plywood
What is the name of the thin inner ring of darts board?
The bullseye.
What is a piece of thin wood used to cover a roof?
The thin piece of wood used to cover a roof is called ply board or deck board. Plyboard is a sheet material manufactured from thin layers or plies of wood veneer that are glued together.
What manufactured board is made from thin sheets of wood?
A thin sheet of wood is a veneer. High quality woods are often shaved into a veneer and then glued onto cheaper woods. It's called paper!My brother thinks it isn't but it is!
What is the name of thin board on which artist mixes colors for painting?
palette
Is plywood a soft or hard?
AnswerHard. It is a board made by sticking thin layers of wood on top of each other ranges from three layers to 5, 7 etc.
Why do you put thin set under backer board?
The thin set under the board is to fill in any low spots in the floor. It is not to adhere the board to the floor. It is preventative against deflection. If there is a low spot and you do not fill it in, the board will flex and the grout/ tile will crack. Do not use construction adhesive it will do more harm then good.
