answersLogoWhite

0

There is a bore brush designed specifically for the M203 (and can also be used with the newer M320, presumably). However, they tend to be a bit uncommon, and you usually end up cleaning them with simple rags and brushes.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What do you use to clean the M203 grenade launcher?

Solvent and a M203 Bore Brush for 40mm.


Why does the wooden clarinet have to be cleaned with bore oil?

Wooden clarinets DO NOT have to be cleaned with bore oil. I have had my clarinets for eight years and have never used bore oil on them. It is a waste of time and money. Any reputable clarinet repairman or clarinetist worth his salt will tell you that bore oil is a waste of time and unnecessary.


Section of gun bore containing the charge?

Chamber or barrel.


What is the Section of gun bore containing the charge called?

Chamber


What kind of weapon is a 37mm launcher?

From the factory, they are a signalling device and are therefore not a weapon at all. You can however register them as a large bore destructive device which allows you to own anti personel munitions with said launcher. If you attempt to possess a non registered launcher and anti personel munitions for said launcher, it is a federal offense.


Will a 305 motor with 350 aluminum heads work?

no, small bore ,big combustion chamber you want big bore small chambers


The bore barrel chamber rails locking lugs and gas tube make up the?

The bore, barrel, chamber, rails, locking lugs, and gas tube are components found in a firearm, specifically a rifle. The bore is the interior of the barrel through which the bullet travels. The barrel houses the bore and directs the bullet's trajectory, while the chamber holds the cartridge before firing. Rails provide a mounting point for accessories, locking lugs secure the bolt in place, and the gas tube directs gas to operate the action.


How does a air rifle work?

It has a chamber that stores air, until released, that propels a projectile down the bore.


Where to use reduced bore and full bore?

Use full bore for applications where pressure drop should be minimum (such as in the suction pipe of a pump with required NPSH very close to available NPSH), or for pipes which could be cleaned with a pig (so that the pig doesn't get stuck on the valve). In other applications a reduced bore should be OK.


Can an hw3 22Lr modified its chamber to fired a wmr22 ammo?

N0- highly dangerous. The bore is also a different diameter.


What are the inside diameters of the bore and chamber of a Stevens 30 caliber rim-fire?

Stevens 30 caliber rim fire is not a true 30 caliber. Chamber is .296. Bore .270 t0 .277. I found a 30 caliber rim fire round, at a gun show. It did not measure out to a 30 cal. Shot shooter


Is an engine's bore a measurement of the combustion chamber or the piston?

The cylinder. When you "Bore Out" an engine block, you're making the combustion chamber wider to accommodate larger pistons to increase horsepower. That's usually mostly done in drag racers, not much use for it in a street car, unless you like supportin' the local Policemans Ball.