answersLogoWhite

0


Best Answer

If the sealant is NON-silicone, then yes, you could paint it. I do not however recommend it.

You best solution to this problem is to remove the old sealant and replace it with fresh bathroom caulk. There are several brands made specifically for use in bathrooms and areas where mould and mildew are common.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: The sealant around your bath has mouldy dark patches in it can you paint over it and if so what paint do you use to cover it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture
Related questions

How do you stop valve cover leak at the front of valve cover at that little half moon on 1989 Nissan 240sx?

remove it, put high temp. RTV sealant around it and put it back


Car cover repair patch?

There are many different kinds of car cover repair patches. These different patches range greatly in price and in color.


Does 95 camaro 3.4 liter need sealant on timing cover gasket?

yes. permatex water pump silacone around the inlet and outlet for the pump.


Is sealant required on rubber valve cover gaskets for a Mitsubishi montero sport?

no its not


Will Excelus Blue Cross cover nicotine patches?

NO


Why do some Olympic swimmers have patches on their backs?

To cover tattoos


Is rtv sealant necessary when replacing intake manifold gasket in 1994 Chevy 5.7 350 engine?

You need the sealant on the ends where the supplied gaskets don't cover fully.


How does the cover come off the headlight on a1998 dodge neon?

You have to pull off the fasteners and use a heat gun around the perimeter to break the bond on the sealant while you pry it apart.


Where is the accent fuel filter located in the 2002 Hyundai?

under the back seat. it has some black sealant around the cover that you can probably reuse. (sticky stuff) just a couple of clips to it.........


Dark patches on skin best cover up?

Concealer or powder.


Your 1999 Oldsmobile Alero thermostat gasket is leaking even after you replaced it how do you fix this?

Rtv sealant, get a new gasket then cover all mating surfaces of the thermostat housing, and the inlet pipe with rtv sealant. Keep in mind that the sealant will squirt out when you the tighten the bolts so don't put too much on there, just enough that a thin bead of sealant is visible all the way around the thermostat after the bolts have been torqued. Make sure to follow the directions on the package and allow the sealant to cure before you add fluid to the cooling system!


Ways to prevent weathering and erosion?

Some of the ways you can prevent weathering and erosion is to cover it with a sealant like paint or epoxy or to just cover it with a sheet