0
The weight lifter used a force of 980N to raise the barbell over her head in 521 seconds approximately how much work did she do in raising the barbell?
Wiki User
∙ 15y ago
5105.8 J
Renee Byrd
Add your answer:
Earn +20 pts
How does the of a 115kg barbell compare to the weight of the lifter?
It would depend on how strong the weight lifter is.
If a weight lifter lifts a barbell and then sets it down is any work done?
Answer: It depends upon your definition of "work". Assuming the lifter put the barbell back exactly where and how it was at first, then there was no work done in the physics context. If you mean manual labor, then yes, some work was done.
A weight lifter lifs a barbell above her head and hold it there where can you infer about the work she is doing?
You can infer that she is working on building up her strength.
Can you use the word squatted in a sentence?
The immense jungle cat squatted silently on the tree limb, patiently awaiting his next meal. The muscular weight-lifter then squatted in front of the huge barbell.
What is the amount of work done by a weight lifter in holding a weight of 100kg on his shoulder for 40 seconds?
While just holding the weight on his shoulder, the weight lifter does no work! For work to be done, the mass must be moved through a distance … No Movement, No Work! (but don't tell that to a weight lifter …)
How can you tell if you have blown lifter?
You can tell if you have a blown lifter by get someone to count of 10 seconds for you and you need to count how many times the noise happens in the 10 seconds and then multiply by 6. That should give you a number. Take that number and then compare it to your idle RPM's. If it's the same as your idle RPMs, then it's likely bottom end knocking. If it's half as fast as your RPMs - then it's valvetrain, like a lifter or an exhaust leak.You can tell if you have a blown lifter by get someone to count of 10 seconds for you and you need to count how many times the noise happens in the 10 seconds and then multiply by 6. That should give you a number. Take that number and then compare it to your idle RPM's. If it's the same as your idle RPMs, then it's likely bottom end knocking. If it's half as fast as your RPMs - then it's valvetrain, like a lifter or an exhaust leak.
What part of speech is lifter?
Lifter is a noun.
What is a car hoist?
a car lifter or a motor lifter
How can you tell the difference between a hydraulic lifter and a mechanical lifter on a Chevy 350 engine?
Take a pushrod and push down on the plunger in the lifter. A hydraulic lifter is spring loaded.
When was Lifter Puller created?
Lifter Puller was created in 1994.
When did Lifter Puller end?
Lifter Puller ended in 2000.
How much does it cost to repair a lifter on a 2004 Camry?
If you a hydrolic lifter... Lifter is about $20 + plus labor 1-2 hours.
