because the switch is closed
All the three would glow at the same instant.
The light is connected in a electrical circuit. The electricity will only pass through the circuit if the circuit is closed. A switch can open and close this circuit by simply not making contact with the next wire so the electricity can not be passed on. When you turn on the switch, the circuit gets closed again and the electricity will run through, so to the light. Because electricity has the speed of light (+-300 000 km/h) it will seems like the electricity reaches the light immediately. Plus the neutral travels through the filement of the bulb and down the switch wire giving an instant closed circuit when switch is closed
A torch is simply a circuit containing a battery, a bulb and a switch. The three components are connected in series (one after the other) to form a loop. The switch simply completes the circuit so that power flows from the battery to the bulb.
An AC wall switch is in series within the parallel circuit of the overall house wiring.
light energy-electrical energy-thermal energy
If the switch, light bulb, and source are all connected in series and the switch is ideal (has no resistance), then the switch acts as a short. There is no potential difference across the short.
a switch and a capacitor which is connected in series with the switch
When a switch is open (wires not connected) it is considered off. When a switch is closed it is considered on. If you move a switch and the wires are not connected the the circuit is open and current cannot run throughout the circuit to power the device.
To control a light with a switch, the switch has to be connected in series with the light fixture.
The on-off switch on your nightstand, which is connected in series with the lightbulb.
It's open and closed circuit.An open circuiit is a break, or disconnection, in a circuit. It could be, for instance, a switch in the "off" position.A closed dircuit is one which is connected (to something). It may be through a switch in the "on" position.
A closed current
If the coil is connected to a circuit and the switch is closed then, provided there is a power source, the coil will become energized.
Isolation switches can be closed with loads connected. The isolation switch should not be opened under load unless the switch is load rated. This information can be found on the isolation switch's cover as to the amount of current that can be safely interrupted.
A normally closed switch is a switch that is normally closed. When you operate it, it opens.
In series. If they are connected in parallel then they won't cut off power supply when they switch off or when they open their contacts.
the electrons are not allowed to enter into the circuit.