I think the flapper is not closing properly. Try adjusting the flapper or replacing the flapper with a new one.
NO.
The toilet only leaks when flushed because there may be a problem with the flushing mechanism or the seal between the tank and the bowl. When the toilet is flushed, water is released from the tank into the bowl, and if there is a leak in the mechanism or seal, water can escape and cause a leak.
Water runs in the toilet bowl to maintain proper water levels and to flush waste down the drain when the toilet is flushed.
The toilet bowl is empty of water because the water has been flushed down the drain, carrying waste with it.
Yes you can flush it. It's possible for a toilet trap to go dry after that much time. When you flush just make sure you check to see if the bowl is leaking.
The toilet flapper stays up to allow water to flow from the tank into the bowl when the toilet is flushed.
To properly flush the toilet, simply press down on the handle located on the side of the toilet tank. This will release water into the bowl, effectively removing waste and sending it down the drain. Make sure to hold the handle down until the water has completely flushed the bowl.
The toilet bowl is empty because the water has been flushed down the drain, leaving the bowl dry until it is refilled with water for the next use.
The purpose of the flapper inside a toilet tank is to control the flow of water from the tank into the toilet bowl when the toilet is flushed.
The purpose of the flapper inside the toilet tank is to control the flow of water from the tank into the toilet bowl when the toilet is flushed.
The purpose of the toilet seal between the tank and bowl is to prevent leaks and ensure a tight connection, allowing water to flow properly from the tank to the bowl when the toilet is flushed.
A toilet may bubble when flushed due to a clog in the drain pipe, causing air to be trapped and released as the water flows through. This can create bubbles in the toilet bowl as the air escapes.