Best Answer

30 nm 180 degrees repeat 180 degrees.

User Avatar

Wiki User

โˆ™ 2006-10-30 21:33:31
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Torque settings for a cylinderhead on a Rover 400 v reg?
Write your answer...

Related Questions

Diagram on how to install a replacement bulb on a rover 400?

You can find a diagram regarding the installation of a replacement ball, on your Range Rover 400, at most Range Rover dealerships. Most auto-parts stores will have the diagram.

How can you bleed a Rover 400 1998 hydraulic clutch?

The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit

Will a torque converter from a turbo 400 trans swap out with a torque converter from a 700r4?


How much torque can you get with 400 horsepower?

Torque(lb/ft) = (5252 * horsepower) / RPM

What is the horsepower rating on 2005 Pontiac gto?

400 horsepower and 400 lb/ft of torque.

How do you access the fuel pump on a Rover 400?

Remove the Fuel Tank

Will a 400 torque converter fit in a 350 transmission?


Where is pollen filter on rover 400?

Filter is located behind the glove box

What are the flywheel bolt torque specs for a 1967 Pontiac 400?

Torque to 95 foot pounds with thread locking compound.

What are the torque specs for polaris scrambler 400?

18 ftlb on the head

Will a turbo 400 torque converter work in turbo 350?


Will a 350 or 400 torque converter work in a powerglide?

A 350 or 400 torque converter will not work on a Powerglide transmission due to differences in design. All are somewhat similar but come in different sizes and connections.

Where is the brake fuse in a rover 400?

Under the bonnet by the battery it also works the horn

How to fit a timing belt on a rover 400?

how often do i have to change the timing belt on my rover400

What is the head torque spec for a polaris scrambler 400?

how do u bypass the oil injection on a polaris 400 2x4 scrambler

What are the torque specs for the main caps on a 1976 Pontiac 400?

The main bolt torque is 100lftlbs and 120 on the rear main cap.

What is the torque of a 1978 Pontiac Trans Am?

About 310-325ft/lbs if its a stock 400.

How much horsepower 07 big bear 400?

500hp and 638 torque

Why does the Heater fan not working at all on rover 400?

you need a new heater fan its burnt out

How to bypass fuel pump relay on Rover 400?

You should not bypass the relay. Repair the problem.

Where is the fuel cut off switch rover 400?

On the rover 416 the fuel cut off switch is behind the centre console drivers side, roughly behind the radio.

Will a turbo 350 torque converter work in a turbo 400?

yes a 350 turbo converter will fit a 400 turbo and vice versa

Head gasket torque specs 1996 xplorer 400?

20 ft. lbs.

Where is the relay for the glow plugs on your Rover 400 diesel P reg?

against the bulkhead, next to the ecu

Will a 400 torque converter work on 350 transmission?

Sorry but it will not I have tried. The 400 is too wide and it won't bolt up correctly when the transmission is installed.