0
For a 2002 Ford Fiesta 1.3 SOHC, the torque setting for the cylinder head bolts is typically around 20 Nm (15 lb-ft) for the initial stage, followed by a final torque of approximately 70 Nm (51 lb-ft) after tightening in the specified sequence. It's important to follow the manufacturer's recommended tightening sequence and perform any necessary angle tightening as specified in the service manual. Always refer to the specific vehicle service manual for the most accurate and detailed instructions.
What else can I help you with?
What is the torque settings for a yz85 2002 head and barrel?
For a 2002 Yamaha YZ85, the torque settings for the cylinder head bolts are typically around 18-20 ft-lbs (24-27 Nm). The torque for the cylinder barrel bolts is generally around 12-15 ft-lbs (16-20 Nm). Always refer to the service manual for the most accurate specifications and ensure proper torque sequence when tightening.
What is the Torque setting on transmission pan bolts 2002 Ford Ranger?
What is the Torque setting on transmission pan bolts 2002 ford ranger?
What do you torque the head on a 2002 Chevy cavalier 2.2 l ohv?
you torque the bolts until they are good and tight
What are the head bolt torque specs for a 2002 Mitsubishi lancer?
10 bolts
How do you torque head bolts on Mazda 2002 protege lx?
check on youtube
What is torque on the head bolts 2002 Cavalier 2.2?
The 2002 Cavalier 2.2 liter engine cylinder head bolt torque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
How do you change the Back shocks of a 2002 Trailblazer?
Remove the bolts. Replace shock. Tighten bolts to the manufacturers recommended torque setting.
2002 Buick Century front hub torque for mounting bolts and axle nut?
34mm
What are the head bolt torque specs for a 2002 kia sportage?
The 2002 Kia had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
What is the torque sequence of a Opel corsa 1.7 utility cylinderead?
2002 opel corsa 1.7 turbo diesel cylinderhead torque settings
What size bolts are holding a 2002 Toyota iac valve?
The idle air control (IAC) valve on a 2002 Toyota typically uses bolts that are 10mm in size. The exact length may vary depending on the specific engine model, but they are usually standard metric bolts. It's recommended to check the vehicle's service manual for the precise specifications and torque settings when replacing or reinstalling the IAC valve.
What is the wheel nut torque on a 2002 Pontiac sunfire?
The lug nut torque specification for a 2002 Sunfire is 90 foot pounds. This is assuming that the rims are factory stocked, as rims with different masses may require different torque settings.
