If it is a Manual 5spd. Then their is a fill bolt and a drain bolt. The drain bolt can be only taken off with an 3/8" socket wrench. And the top fill bolt which is all next to the passenger side axle. The bolt should be a 17mm.
To add transmission fluid to a 1990 Acura Integra LS, first, locate the transmission dipstick, usually found near the back of the engine bay. Ensure the engine is warm and running, then remove the dipstick, wipe it clean, and reinsert it to check the fluid level. If it's low, use a funnel to add the appropriate type of transmission fluid through the dipstick tube, being careful not to overfill. Recheck the level after adding fluid to ensure it’s within the recommended range.
No, 90-93 was cable operated, 94-up was hydraulic.
No but to me it's just easier
Save up your money and have the job done by a pro, honestly, its a pain and not worth the savings.
Yes it should. Im 99% sure it will. you might want to double check the part number to see for sure. i have a 1990 Acura integra and i have used many parts from integras from 1990- 1993.
wiper intermittent relay 1990 acura integra
if its an automatic transmission theres a dipstick on top of the transmission, look above it. It will be to the right of the battery behind some hoses and have a yellow handle.If its a manual (5 speed) there is no disptick.... theres a 17mm bolt (metric thread) that can be removed from the bottom on the transmission. Its on the passenger side.
1/2 drive Ratchet
z1 atf get at Honda dealer
There is no filter in a manual tranny. if you have an automatic there is still no removable filter in it.
Yes, It will fit a 90-93
how do you replace an alternator on a 1990 integra