Pick up coil?
its the bottom plate that moves in the distributor to advance the timing
remove bottom pully then you will need special puller for the lt1if you are trying this you should get a book
There is a oil pump drive rod that fits into the bottom of the distributor and the gear that's on the bottom of the distributor runs on the gear that's on the rear of the camshaft.
Inside the engine oil pan, at the bottom of the distributor drive shaft.Inside the engine oil pan, at the bottom of the distributor drive shaft.
Should have a horseshoe type locking bolt at the bottom side of distributor--remove and twist to lift out
www.msdignition.com/pdf/8356_frm25675.pdf
The distributor will need to be removed. The magnet is permanently attached to the distributor shaft and the shaft is held in place by a roll-pin thatpasses through the distributor drive gear on the bottom side of the distributor. Magnet on top, gear down in the engine, distributor shaft and housing in the middle.
The Sim tracker is in the bottom of your screen. The icon is a picture of your Sims. To use it click on it and it will pull up. Then you are able to click on the Sim you want to control.
The Sim tracker is in the bottom of your screen. The icon is a picture of your Sims. To use it click on it and it will pull up. Then you are able to click on the Sim you want to control.
When standing on the passanger side looking at the distributor the top right plug is cylinder one (the cylinder closest to the distributor). The top left plug on the distributor is cylinder two. The bottom left plug is cylinder three. Finally the bottom left plug is cylinder four (the cylinder furthest from the distributor, closest to the timing gear). Hope this helps.
A keyway on the bottom of the distributor.
In the bottom of the distributor under coil.