0
49"
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How high from the floor do the plug-ins and light switches have to be in South Carolina?
There is no minimum, just a maximum. You can't put them higher than 6'7".
You changed one headlight on a 2000 Ford Windstar and installed both new bulbs now high beam does not work what is wrong?
check the switch or replace the one on the steering column that switches between high and low beams
Can you install laminate floor over laminate floor?
No, laminate is floating type of floor installed over an insulation pad. Hardwood floor has to be nailed, stapled or glued to the subfloor. If you do manage to install hardwood on top of laminate sooner or later your Laminate floor will expand due to high temperature or humidity and it will create gaps between hardwood planks.
What is the height of electrical outlet from floor?
Answer for USAThe NEC requires that required outlets be installed anywhere from 5 feet high on the wall to as much as 18 inches from the wall on the floor. However, they are typically placed from 12-18 inches high on the wall. This is purely arbitrary, depending on what you think looks best and how accessible you want them to be.It is important that you note I said this is what is required for required outlets. You can place an outlet anywhere you wish, except face-up in a counter. Just if it does not fall within the measurements I gave above the outlet doesn't qualify for what is a required outlet.Before you do any work yourselfon circuits, equipment or appliances,ensure the circuit is, in fact, OFF.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
How much horsepower does a Chevy 400 smallblock have?
It depends on what year it was made, and what it was installed in. Chevrolet never made a high performance 400 small block. They used the 396/402 for high performance applications. The small block 400 was typically installed in heavy cars like station wagons.
Where is the reset switch for the fuel pump on a Oldsmobile intrigue?
reset swith is usually under floor mat high up under dashboard on driver side GM vehicles do not use inertia/reset switches.
How close to the floor can a circuit breaker box be in a wet basement?
The Bottom of the Panel Box should be installed no less than 6 feet 6 inches from the finish Floor. <<>> The CEC states that panelboards in dwelling units shall be installed as high as possible, with no overcurrent device operating handle positioned more than 1.7 m (67") above the finished floor level.
Why will my high beams work but my low beams do not on my 1994 Chevy half ton?
Your high beams work but your low beams do not because the switch is broken that switches between high and low beams. Electrical switches wear out.
How many ports are there in a network switch and how are they connected?
There are typically 5 to 24 ports on a network switch, though real high end switches can house more. Internally the ports are connected with copper wires.
How do you switch high and low beams on a 1970 Volkswagen Beetle?
Pull the turn signal switch toward you. First pull switches from low to high, second switches back to low.
Can you install hardwood flooring over laminate flooring?
No, laminate is floating type of floor installed over an insulation pad. Hardwood floor has to be nailed, stapled or glued to the subfloor. If you do manage to install hardwood on top of laminate sooner or later your Laminate floor will expand due to high temperature or humidity and it will create gaps between hardwood planks.
What is a cleaning trolley typically used for?
A cleaning trolley is typically used to reach and clean high windows. This is an elevator type scaffold that goes down or up the side of buildings to clean all windows above the ground floor.
