0
Stage Clips.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How can you prevent your slide from slipping on the stage on a microscope?
Most microscope stages have clips for holding the slide. If you do not have any clips on your microscope stage, you can use tape to hold the slide in place.
Do the doors fix in place with magnets or do they use some type of latch or indention to hold the doors shut?
The doors use magnets to hold them shut. The doors have knobs for opening.
Which lens should you use to first look at a slide on a microscope?
The lens that you should use to first look at a slide on a microscope is a low power lens then move on to a higher power for more clarity.
What is the only instrument to use a slide mechanism to reach notes?
Trombone
How do you use hold steady in a sentence?
Hold steady! (declarative sentence) If you don't hold steady, I can't brush your hair. Note: In the United States, we use 'hold still'. Hold steady sounds too formal, too stiff.
What does the stage clips of a microscope do.?
it is use to hold your glass slide/specimen slide in place.
How can you prevent your slide from slipping on the stage on a microscope?
Most microscope stages have clips for holding the slide. If you do not have any clips on your microscope stage, you can use tape to hold the slide in place.
Stage clips on a microscope?
it's support the specimen in the glass ---- Love_u ------
What do you use to make sure your specimen remains in place in the slide?
stage clips
What are differences between microscopes now and then?
The old microscopes use a mirror and the sun. It has weaker magnifying power and no stage clips. The new ones have a light source that runs on electricity. The magnifying power is stronger and it has stage clips to hold the slide in place.
How is a slide observed under the microscope?
This would depend on the type of slide and type of microscope; however, typically you turn on your light source (either electric or sometimes a mirror to reflect the ambient light), switch your magnification to the lowest power (usually scanning at 4X) place the slide on the stand and hold it with two clips, adjust the height of the stand with the gross adjustment knob (larger) until the image comes into view, then use the fine adjustment knob to focus the image. You can then change magnification power as high as your microscope will go. Note: If your microscope has a 1000X oil immersion setting, make sure to follow the instructions for oil immersion or you can damage your lense. Also, once you get past the 10X, only use the fine adjustment knob or you can damage the lense.
How does a microscope use light?
Microscopes use light to illuminate the stage where you place a slide for viewing. Without this light, you would be unable to see much of anything.
How do you use a jar on a computer?
In a desktop computer, with a slide-out optical unit, you open the tray and then you can place either a glass, a cup or a jar in the center hole to hold it
Use of glass slide?
it is use to place an item on and put it under a microscope to view
How do you remove the radio out of a 1989 Mercedes 260e?
There are two clips that hold the radio in place. You just need to use a hook tool and remove the clips and the radio will slide out.Ê
What would you use to place water on a slide?
a water hose
What safety measures you might take to avoid damaging the microscope microscope slide or a living specimen on your microscope stage?
1) When you pick up the microscope and walk with it, hold it with two hands. Use one to hold the arm and one to hold the base. 2) Always make sure your on the lowest magnification when using it and that the stage is all the way down 3) use a chem wipe to clean everything off.. dont worry too much about the microscope slides.. if its just a plain slide they are usually not too expensive 4) Move slowly and you'll be fine.. doing everything slowly also helps the experiment run better
