answersLogoWhite

0

Using 10w30 on a chrysler 300 bad?

User Avatar

Anonymous

11y ago
Updated: 8/17/2019

3.5L, no.

2.7L, maybe- should be 5w30

5.7L, yes. Needs to be 5w20.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What are the signs of the egr valve going bad in a Chrysler 300?

Check engine light on


What do I need to know before I buy a Chrysler 300?

It is probably not wise to purchase a Chrysler 300. These cars have been subjected to numerous recalls and the corporation has a bad reputation. Chrysler is also experiencing extensive restruturing. A common recall for the Model 300 relates to their brakes which can fail.


How can you tell when my Chrysler 300's CV Driveshaft is bad?

A faulty Chrysler 300 driveshaft will make a clunking noise as it turns. The driveshaft noise can be best heard when moving very slowly.


Why Chrysler 300 has a loud ac noise?

Inadequate oil in a/c comp, bad bearings,bad clutch are possible causes.


1999 Chrysler 300 just click when trying to start?

Weak battery. Which may in turn be caused by a bad alternator.


Symptoms of bad camshaft position sensor?

A bad crankshaft position sensor on your Chrysler 300 will cause the engine to run very rough or not run at all. The malfunctioning sensor can cause damage to your engine, if not repaired.


What are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi?

what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi


Where is the starter relay fuse on a Chrysler 300?

The fuse box under the hood. It is the #9 relay and when it starts to go bad there is a delay before engine cranks over.


What oil and how much should be use in a ktm exc 300?

ktm recommend you use a 10w30 oil for the 2 stroke and you will need 0.75 litres make sure you get all the old oil out though otherwise you will overfill it and that can be as bad as under filling it ..


How can you tell when my 2001 Chrysler 300's CV Driveshaft is bad?

They will likely make a clickety clackety sound when steering wheel is in full lock and car is moving either to right or left.


Is it bad to go from 10w30 to 5w30?

Always use exactly the weight of oil recommended by the engineers who designed and built the engine in your car. Using any other weight can cause premature engine wear over time.


2006 Chrysler 300c died while driving down the Interstate. Electrical system was working fine what could be the issue?

A bad fuel pump can cause your 2006 Chrysler 300 engine to shut off. Many times the fuel pump does not give any warning, it just stops working.