Want this question answered?
There is no such a thing as a thermocouple volt meter. A analogue or digital millivolt meter or volt meter is connected across a shunt or parallel with the shunt to measure the current through the resistor. Say the resistor value = 1 Ohm, then by using the Ohm law formula to calculate the current, say the voltage (voltage drop), read on the volt meter is 1.5 Volt that is R*V = A that is, 1Ω*1.5V = 1.5 Amp. Any type of DC volt meter, analogue or digital can be used to measure the voltage across a capacitor if the value of the capacitor is large enough that reading will be true RMS. as long as the supply current (EMF Power) are larger than the load current.
Write down the Ohm's law expression of "V = I * R" where "V" is the voltage drop across shunt resistor, "I" is the current flowing through shunt and "R" is the shunt resistance.Substitute value of voltage "V" and current "I" in the Ohm's law expression. For example, if voltage across shunt is 10 volts and current flowing through it is 1 ampere, then the expression is 10 = 100 * R.Divide the expression throughout by 100 to calculate the "R" value. Using a calculator, find the value of "R." From the example, the value of "R" will be 0.1 ohm, which is the value of shunt resistor.
1 Ohm meter X (Mega Ohm/ 1000 Ohms) X (100 cm/meter) = 100/1000 Mega Ohm cm = 0.1 Mega Ohm cm method: dimensional analysis
Capacitance is measured in Farads. "The unit... in ohm and meter" does not make sense.
if it is ohm meter and not ohm per metre; divide by 1,000,000 to convert ohm to megaohm, then divide by 1000 further to convert metre into kilometre
Ohm meter
You can check glow plugs with an ohm meter. should be <1ohm
To ohm out a motor one would use an ohm meter. If one does not own or can not obtain a meter, the motor can be taken to a shop and ohmed out there for a fee.
ohm meter
With an Ohm meter.
By ohm meter.
An ohm meter doesn't put out enough voltage, you need to use a megger.