The water instantly cools one condenced.
it depends how cold or warm the condencer is and how long it takes for the water to flow threw it.
To change a condenser in a 2001 Kia Sephia you need to disconnect the refrigerant lines and unbolting the condenser. Lift the condensers out and replace with the new one.
Water vapor changes as it passes down the glass tube in the condenser by cooling down and condensing into liquid water due to the lower temperature of the condenser. This conversion from a gas to a liquid occurs as the vapor gives off heat to the surrounding environment and undergoes a phase change.
I have a 1992 De Ville and the condenser is plugged. Is there a step by step over view of this project?
Very Carefully
The amount of heat required depends on the desired temperature change. For example, to raise 1500 g of water by 1 degree Celsius, it would require 1500 calories (1 calorie per gram per degree Celsius).
To change the AC condenser on a Mitsubishi L300, first ensure the vehicle is off and disconnected from the battery. Remove any components obstructing access to the condenser, such as the front grille and radiator. Then, disconnect the refrigerant lines and electrical connections from the condenser, followed by unbolting it from its mounts. Install the new condenser by reversing the process, ensuring all connections are secure and the system is recharged with refrigerant.
If you have a bad condenser your car won't run. Always carry a spare set of points and condenser (you change them together) in the glovebox.
This equipment is called condenser.
as heat is removed from the refrigerant at the condenser it reach it saturated temperature n then it'll start to flash change state to a high pressure liquid LBMDOLPH-CHECKMATE on soundcloud
To change the condenser on a 1999 Chevy Lumina with a 3.8L engine, first disconnect the negative battery cable and discharge the A/C system properly. Remove the front grille and radiator support to access the condenser. Disconnect the refrigerant lines, electrical connectors, and any mounting bolts holding the condenser in place. Finally, install the new condenser by reversing the removal steps and recharge the A/C system.
A condenser. In the Chemistry Lab a condenser consists of a tube which is supplied with cold water. This tube surrounds another tube running through it which has the vapour passing through it. The vapour condenses into a receiver.