answersLogoWhite

0

To make your heaters work, make sure you have water in the water tank under the bonnet. You cant miss it. I had that problem with a corsa sxi, I didnt have any water in the tank hense my heaters wouldn't work.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace heater blower corsa D?

The heater switch can be replaced on a Chevrolet Corsica by removing the three wires from the back of the switch. Put the wires onto the new switch and return it to its slot.


Can you put a heater in a cold water tank?

yes


How do you get rid of dirt in bottom of hot water heater?

Why would anyone put dirt in a water heater ?? Normally water heaters have sediment from the minerials in the water supply and the instructions furnished with the heater tells how to cure this problem


Why do you put a bowl of water in front of the heater?

Being in a closed room with the heater on become stuffy an losers oxygen.


Can you fill a children's pool using a hot water heater?

Yes! Connect a garden hose to the output valve of the water heater and open the water heater valve to put hot water into the kiddie pool. This is the fastest way to warm a children's pool.


If i am not using the car heater can i put a plug in the intake and water pump?

yes


Diagram of corsa Engine?

I cant put my corsa into gear it is going from side to side and losing power


How do you put water in a radiator of 1996 Opel Corsa?

via the Round expansion tank that is on Right hand side of the bulkhead. half fill with water, its marked. That's it.


Where can you get a diagram showing how to put back water lines for the heater?

By contacting the various manufacturers


Can you put a regular hot water heater in a mobile home?

Yes, you can. That is the common fit.


What gearbox oil do i put in a vauxhall corsa?

Bt402


How do I replace the thermostat on a water heater?

To replace the thermostat on a water heater, first turn off the power and water supply to the heater. Remove the access panel and insulation to access the thermostat. Disconnect the wires and remove the old thermostat. Install the new thermostat, reconnect the wires, and put everything back together. Turn the power and water supply back on and test the water heater.