0
A cam sensor and crank sensor was not used on that year. If the engine is not firing then I would replace the ignition module that's in the distributor.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the cam sensor on a 1993 Chevy S10 2.8 liter V6?
The cam sensor is the distributor.
Does a 1995 S10 2.2 L 4-cylinder have both a cam sensor and a crank sensor?
No cam, but yes crank
Where is the cam position sensor on a 1994 Chevy s10 4.3?
In the distributor.
Where is the Cam Sensor on a 1995 S10 blazer 6 cylinder?
The 95 S10 4.3L still uses the distributor.
Where is the cam position sensor on a 2000 Chevy s10 4.3?
Inside the distributor.
Where is the cam shaft position sensor on a 1996 Chevy s10 4.3L pick up?
That would be the distributor.
Where is the cam position sensor on a 1998 Chevy s10 2.2 liter?
In the right upper side (passenger side) of engine block.
Is a 1995 S10 engine compatible with a 1999 S10?
No it will not. 1994 and 1995 only will from car or truck. 1996 went to a different computer system, fuel injection, camshaft, cam sensor, etc.
Where is the MAF sensor located on a 1994 Chevy s10?
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
Will 94 s10 2.2 work in 96 s10 2.2?
no because in 1996 gm switched the fuel injection to sequential fuel injection. If you will look on the 97 block there will be a cam sensor on the right side (passenger). the cam sensor was not put there until 96. the 94-95 did not have this. However I believe you could use the wiring harness and ECM from the 94 as well to get you going. Hope this helps
Does a Chevrolet 2.2 have a cam position sensor?
The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.
Where is the cam sensor on a 1985 celebrity Chevrolet?
That year did not have a cam sensor.
