0
The crankshaft position sensor is located behind the harmonic balancer. You will need a harmonic balancer puller and an impact wrench good for at least 750 ft pounds. Access the harmonic balancer through the passenger side wheel well. Remove the harmonic balancer center bolt and use the puller to remove the balancer. Use 1/4 - 28 X 3 inch bolts on the puller. The sensor is held with two screws. Be careful not to damage the weatherpack connector when releasing it from the sensor.
What else can I help you with?
Were is purge valve on a 1997 Pontiac Grand Prix 3.8?
For my 1997 Grand Pri SE 3.8 it is located underneath the engine cover on the front of the engine near the fuel rail. It also has a evap air control valve at the rear thtaes up part of the circuit.
How do unlock daisy on Mario Kart ds?
To unlock caracters (including Daisy) and cups you have to go onto Grand Pri. Then win all the races in a cup and If you do well it will unlock something. You can only unlock stuff on grand pri though.
Who was the first English world grand pri champion?
The first ever English F1 racing grand prix champion was Mike Hawthorn in the year 1958. He drove for Ferrari.
What does the prefix pri mean?
Pri-first-(primary)
What is the population of Selo pri Ihanu?
The population of Selo pri Ihanu is approximately 400 residents.
What is the population of Sela pri Kamniku?
The population of Sela pri Kamniku is approximately 160 people.
How signaling is done from eapbx through isdn pri?
The ISDN pri was mapped with the EAPBX while some programming was made on the pbx. Then the signals from the PRI lines was routed to the pbx through the PRI card in the EAPBX.
Can you convert a rack and pinion from rear steer to front steer?
You can do anything to a vehicle with a cutting torch and a welder, and a little know how. There are kits for a variety of vehicles that can be simply bolted on and then there are cars like the 1969-70 Ford Gallaxie that you have to cut andprie and before you know it a 2006 Pontiac Grand Pri R/P is sitting under it, by the way if you have access to a mill and lathe you will need it.
What is the population of Breg pri Polzeli?
The population of Breg pri Polzeli is 805.
What is the population of Sela pri Šumberku?
Sela pri Šumberku's population is 100.
What is the population of Znojile pri Krki?
The population of Znojile pri Krki is 112.
What is the population of Dobrova pri Dravogradu?
Dobrova pri Dravogradu's population is 170.
