answersLogoWhite

0

It's located under the car just behind the starter. Both sensors are there. The Throtle sensor and the Crankshaft sensor. You have to take out the starter to get to it.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the Chevy Aveo crankshaft position sensor?

Locate crank shaft sensor 2005 Chevy aveo


Crankshaft position sensor for 2005 Chevy Cobalt?

way is my crank sensor over heating on my 2005 colbalt


Are 2002 Chevy cavaliers and 2005 Chevy cavaliers compatible?

yes 100 %


Were is crankshaft sensor on Mitsubishi lancer?

were is the crankshaft sensor on 2005 mitsubishi lancer


Is Chevy still producing Cavaliers?

No, Chevy no longer produces Cavaliers. Chevy has not produced the model for nearly five years, as they stopped producing the model in 2005.


What wires are only needed for the engine to run on a 1995-2005 Chevy Cavaliers?

The 10.2mm spark plug wires are the wires that are only needed for the engine to run on a 1995-2005 Chevy Cavaliers.


Nissan Frontier 2005?

Crankshaft sensor


Where is the crankshaft position sensor on a 2005 dodge caravan sxt?

The crankshaft position sensor on a 2005 dodge caravan is mounted on the top side of the bell-housing.


Where is the crank sensor on a 2005 Chevy Impala?

where is the crank sensor located on a 2005 chevy impala


Where is crank sensor on 2005 Chevy Express?

On a 2005 Chevy Express, the crankshaft position sensor is located on the engine block, near the crankshaft pulley. It is typically positioned towards the lower part of the engine, close to the transmission bell housing. To access it, you may need to remove some components for better visibility. Always refer to a repair manual for specific guidance on your vehicle.


What was the last year Chevy Cavaliers were made?

Chevrolet Cavaliers were last made in 2005 where the new Chevrolet Cobalt took its place


Where the crankshaft position sensor is located on 2005 Kia Sedona?

The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.