answersLogoWhite

0


Best Answer
Copy

Were is the timing mark an a 1994 Nissan Sentra 1.6l?

User Avatar

Wiki User

โˆ™ 2011-09-13 17:06:54
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Were is the timing mark an a 1994 Nissan Sentra 1.6l?
Write your answer...
Submit

Related Questions

Where is the timing mark for Plymouth acclaim 1994 2.5 liter?

where is the timing mark for Plymouth acclaim 1994 2.5 liter?


Where is the Nissan laurel diesel RD28 timing marks?

where is the nissan laurel diesel rd28 engine timing mark


Timing chain mark for Nissan frontier 2.5 turbo?

i want to know timing chain nissan frontier marking


2002 Nissan Altima 2.5 engine timing marks?

nissan altima 2.5 timig mark


On a 1994 ford aerostar how do you reach the timing mark with a timing gun with the pulleys in the way?

get at it from the bottom get a white marker and mark the timing spot then go up top and you should be able to see it


When should you change the timing belt on 2007 Nissan qashqai?

around the 70,000 miles mark


Why wont your 1994 Nissan Pathfinder start strong gas smell just replaced water pump?

Timming is off. I replaced the water pump on my 95 pathfinder and the fact that the timing belt has to be removed, there is a good chance that one of the cams turned. When the timing marks are lined up, it does not take much for one of the cams to get off its mark. Even a slight bump will do it, and it doesn't help that Nissan does not make the timing marks that visible to see. I used white paint and a small detail brush to mark the timing marks.


What is the timing mark on a 1989 Nissan ka24e motor?

red mark is TDC. 15 degrees BTDC where you want to be is 3 marks after TDC.


When timing the timing belt do you use the mark for top dead center on the crank or the mark on the oil pump next to the crank I have a Nov 1994 date of manufacturing 3.2 Isuzu Rodeo?

When timing the timing belt you use the mark for top dead center on the crank. To do that you will have to do a few different steps.


Where are the timing belt marks on a 1987 Nissan Stanza timing belt marks?

at top dead center, camshaft mark at 12 o'clock and crank at 5 o'clock. belt should also have marks if it a Nissan belt.


Where could you find a picture of the timing marks on a Nissan model 85 pickup?

The sticker on the top right of the underside of the hood should have a picture of factory spec timing mark.


What are the timing mark setting on a 2001 Mitsubishi Galant 2.4L?

2.4l dohc balance shaft timing mark, crankshaft sprocket timing mark,oil pump timing mark and camshaft TWO timing marks 2.4l sohc balance shft timing mark, crankshaft timing mark, oil pump timing mark and ONE camshaft timing mark. it is complicated only that everymark must be bang on, if not the pistons will hit the valves and YOU get to rebuild engine.


Where is the timing mark location on a 1987 motor Chevy 350?

there will be a timing mark on the harmonic balancer. and a timing tab on the timing chain cover. point your timing light at the timing tab and you should see the timing mark on balancer. if not timing is way out.markstang.


Where are the timing marks for Nissan Serena 2.3 diesel 95?

The timing marks are on the belt and the sprockets. not on the engine! the box that the belt is supplied in shows the mark locations. well i use Gates belts and these do!


How do you change the head gasket on a Nissan 2.3 diesel as in a 1994 Serena?

Rocker cover off. Timing belt cover off. Exhaust manifold off. Mark timing belt and gears if no marks on both already. Timing belt off. Head bolts out. Remove head. Change gasket. Re-fit all bits. Match up the marks on the timing belt with the marks on the gears for the timing to be correct. Torque the head bolts to... 1) 100Nm 2) 90 degrees 3) 90 degrees Refit rocker cover. Job done. Same engine as in the LDV Cub and Nissan Vanette.


Knock sensor location 1994 mark 8?

The knock sensor on a 1994 Lincoln Mark 8 is located on top of the engine, near the upper radiator hose. It constantly monitors for the distinctive knock made from incorrect ignition timing.


Where is the timing mark on the crank shaft for a 1994 Chevy 350?

it is located on the harmonic balancer outer edge even with the crankshft "key"


Citroen relay timing marks?

timing mark


What is the timing mark for a 1974 dodge dart 318?

The timing mark is a line that goes across the harmonic balancer that should line up with the mark on the timing chain cover. It is on the drivers side on the bottom of the timing cover.


Where do you set crank and cam shaft marks to set timing on a 1996 Nissan Pathfinder?

Where do you set crank and cam shaft marks to set timing on a 1996 Nissan Pathfinder?" Did the timing belt snap ? if so the engine will have bent valves and require more work than just the belt. This is timing belt job is not one for the inexperienced diy mechanic. Not trying to be a wise guy, but get the manual, the timing mark set up isn't a simple explanation .


What are the timing marks and how are they lined up on a 1994 Geo Metro 3 cylinder?

on the balencer there is a timing mark and om the motor theres a tab there is also a mark on the cam gear, when lined up, both marks on the crank gear and cam gear point up.


Where is the timing mark on a Chevy 1500 with a 350?

The timing mark is one the Harmonic balancer and the pointer is attached to the timing cover. Roll the motor over to the timing mark, the be sure and mark the number one plug {marked on the intake manifold} the position of the rotor pointer on the distributer.


If there is no timing mark on the timing cover of a 350 how can you set timing?

you can purchase an aftermarket timing tab which bolts to the timing cover.


Where is the timing mark on the oil pump housing that is supposed to match with the crankshaft sprocket on a 1992 Nissan Pathfinder with an XEV6VG30E modelengine?

bottom of case on driver side, it is a notch


What is the timing mark on a 1989 Nissan v 6 pickup?

This comes from the Haynes Repair Manual for Nissan Pickups (1980 - 1996) and Pathfinders (1987 - 1995) on pages 1-38, 1-39, Figure 48.4 and page 2B-4. "The timing marks are on the vibration damper and a pointer is attached to the engine." There should be four marks on the vibration damper about a quarter inch apart. Each mark represents ten degrees. The zero degree mark is the first mark to cross the pointer as the engine is turning. I have three drive belts and the timing marks are on the outer rim of the second crankshaft pulley.