The metering device. Depending on what type of system you have, this will either be a Fixed Orifice Tube or it will be a Thermal Expansion Valve.
Metering device
Metering divice
The compressor changes the low pressure gas into a high pressure gas which then has the heat of compression removed in the condensor to turn it into a high pressure liquid.
as heat is removed from the refrigerant at the condenser it reach it saturated temperature n then it'll start to flash change state to a high pressure liquid LBMDOLPH-CHECKMATE on soundcloud
Starting at the compressor;Low pressure vapor refrigerant is compressed and discharged out of the compressor.The refrigerant at this point is a high temperature, high pressure, superheated vapor.The high pressure refrigerant flows to the condenser by way of the "Discharge Line".The condenser changes the high pressure refrigerant from a high temperature vapor to a low temperature liquid and leaves through the "Liquid Line".The high pressure refrigerant then flows through a filter dryer to the Thermal Expansion valve or TXV.The TXV meters the correct amount of liquid refrigerant into the evaporator.As the TXV meters the refrigerant, the high pressure liquid changes to a low pressure, low temperature, saturated vapor.This saturated vapor enters the evaporator and is changed to a low pressure dry vapor.The low pressure dry vapor is then returned to the compressor in the "Suction line".The cycle then starts over.
A volatile liquid
No , a high temperature high pressure ( gas )
If the pressure of the gas increase, the solubility in a liquid increase.
The melting point of a solid is the temperature at which it changes STATE from SOLID to LIQUID. At the melting point the solid and liquid phase exist in equilibrium. The melting point of a substance depends (usually slightly) on pressure and is usually specified at STANDARDatmospheric pressure.
High pressure line is connected to the output of compressor and contains highpressure and high temperature gas entering the Condensor from top. It is forcefully cooled in condensor and with reduction in tepmerature gas changes its form to liquid which will be collected from bottom of the condensor.
The melting point of a solid is the temperature at which it changes STATE from SOLID to LIQUID. At the melting point the solid and liquid phase exist in equilibrium. The melting point of a substance depends (usually slightly) on pressure and is usually specified at STANDARDatmospheric pressure.
high pressure vapor