How do you clean a project salvo paintball gun?
Unscrew the barrel, take off the hopper. Then unscrew all of the
medium screws and take the shroud out and the left receiver half
off. then lift up the stock out of its set rings and relive
pressure on the main spring. Flip the silver connector above the
the front and rear bolts. Take it out and lubricate the rubber
orings on both the bolts. Use only airtool or paintball
lubericants, do not use aerosols like WD40 Clean out any other
paint, dirt or grease with a paper towel. Put all of the parts back
into place (there are may videos of this) then rescrew the screws
in the marker.