HBC (High Breaking Capacity, European term) and HRC (High Rupturing Capacity, North American term) fuses have the ability to break high fault currents. This is done by having silica sand in the fuse that the fuse elements travel through. On high fault current that sand will melt and turn to glass. This breaks the current flow immediatelyA cartridge fuse maximum current breaking capacity is very much lower than HRC, HBC because there is nothing in the fuse body except the fuse elements.
If an MCB trips you can simply close it and be done. If a fuse blows you need to replace the fuse /fuse wire, not so convenient.
By referring to the manufacturer's characteristic curves for the fuse. There are different curves for different types of fuse (e.g. rewirable, cartridge, etc.). Essentially, these curve will tell you how quickly the fuse will operate for any value of overload current.
When my printer cartridge was empty, I replaced it with one I had bought over the internet.
If the circuit develops a fault which causes a dangerous over-current condition - which would have caused the original piece of fuse wire to melt and thus break the circuit before anything catches on fire - then doing the kind of vandalism to a fuse carrier, as is possibly being described by this question, is a negligent and highly dangerous act.For a re-wireable fuse, using two pieces of fuse wire instead of one - or using a paper clip, a nail or any other piece of metal which is not the correct fuse wire - is:highly dangerous as it is a major cause of house-firescould mean that your house would no longer be covered for fire damagean illegal act in some countries which, if proven, could result in criminal prosecution followed by a heavy fine and/or imprisonment.To summarize:If this question is asking if it would be useful, in a re-wireable fuse carrier, to replace a single length of fuse wire by two lengths of fuse wire, wired in parallel, the answer is NO because one length of fuse wire should only ever be replaced by ONE length of the correct amperage rating, which means it must be fuse wire of an identical gauge and material as the original.If this question is asking if it would be useful to replace a single cartridge fuse by two similar cartridge fuses connected in parallel, the answer is NO because the extra fuse would not be able to offer the same protection to the circuit as the original single fuse was intended to do. A single cartridge fuse should only ever be replaced by ONE cartridge fuse of the same identical size and amperage rating.If this question is asking if it would be useful to replace a single cartridge fuse by two similar cartridge fuses connected in series, the answer is NO. The additional fuse would serve no useful purpose. A single cartridge fuse should only ever be replaced by ONE cartridge fuse of the same identical size and amperage rating.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
Cartridge head cleaners are special liquids made to unclog the clogged ink particles over the cartridge head and inside the cartridge. once a cartridge runs out or you don't use it for while the left over ink clog's . When you want refill the cartridge or reuse it - if the ink is left - you should unclog the cartridge so the ink can flow with ease. The best anticloging agent is an alcohol like isopropyl alcohol.
open the top, flip the tab over the ink cartridge up, pull out ink cartridge, replace ink cartridge, flip tab back down over ink cartridge, close top.. A: just make sure it is properly inserted. and try to clean it first.
Cartridge World originally founded in Adelaide, Australia in 1988. There are currently over 560 stores in the US and Canada and over 1,400 stores in 52 countries.
advantages of hartnell governor over porter governor
List two advantages that corporation have over a small business
She didn't. Fuse was screwing her over and she quit.
There is no direction eqivalent in non-metric cartridges- this was developed as a metric cartridge. The bullet is ABOUT .244 inches in diameter, and the cartridge case a little over 1 inch long. It is similar to, but not the same as the .22 Hornet cartridge.