Binary is easier for the computer to understand. It is also easier to handle and is not costly.
•
Binary codes for decimal digits require a minimum of four bits. Numerous different codes can be obtained by arranging four or more bits in ten distinct possible combinations.
Excess 3 code in computer, is defined as a number code in which the decimal digit 'n' is represented by the four bit binary equivalent of n + 3. Symbolically can be represented as XS-3 code.
Binary is a system of numbers that a computer uses to record data. It is simpler than decimal as its only characters are 0 and 1 while decimal has 0 1 2 3 4 5 6 7 8 and 9. A computer can more easily record "on off" or 10 than it can 2. in the same way it can more easily record 11 than 3, 100 than 4 101 than 5 110 than 6 etc. So basically, Binary is just a simpler way of recording the same numbers as decimal, and is much easier for computers to use to store data than decimal as they can just store their bytes as packets of on off on off and that converts on the screen to numbers letters and pixels. oh and your mouse is dependent on binary too.
An integer is a datatype which represents every positive and negative natural number. Additionally it can represent zero, but no decimal numbers. However, the actual size of the integer my be limited by the operating system.
1.2E4 edit: 12000 is already in decimal form
ABC-1039 The Atanasoff-Berry Computer was the world's first electronic digital computer. It wasbuilt by John Vincent Atanasoff and Clifford Berry at Iowa State University during 1937-42. It incorporated several major innovations in computing including the use of binary arithmetic, regenerative memory, parallel processing, and separation of memory and computing functions.
decimal computer
Depends on the type of operation.
1836 can't be made into a decimal without an operation occuring. If you just want it as an decimal, then its going to be 1836.0
Add, subtract, multiply and divide.
The 4 basic operation on decimal are subtraction, multiplication, addition, and division. by: queeny nathalie astudillo try this.....
That's a very difficult operation, because 0.4 is already rounded to one decimal place.
69
No.
dividing the number by a power of 10
Any number or decimal number that can be expressed as fraction is rational.
1. You must first go to the place in front of the decimal and round that number 2. Do the same for the next number 3. Lastly do the operation to find your answer
BCD is a decimal number. BCD is one specific way to store decimal numbers in computer memory.