There is one solenoid on the charcoal evap. canister in the engine compartment. There is another one located near the gas tank underneath the chassis. That is the one that usually goes bad as road salt and moisture attack that one.
It depends on which solenoid you mean. The STARTERsolenoid is integral to the starter.
Trouble code P0441 means:Evaporative emission control system,incorrect purge flow
The EVAP vent solenoid on a 2006 GMC Sierra is on the driver's side of the vehicle. It is on a bracket next to the gas tank.
Starter solenoid? One top of starter--follow + battery cable
I have a 1991 Sierra and my ESC is located right on top of the motor directly to the left of the carburetor.
Shift solenoids are located on the rear of the valve body inside the transmission oil pan.If you are not careful removing the pan you can damage them.
there should be a eng. info and emission sticker in the eng compartment it will say California emission on it
On a 2009 GMC Sierra, the purge valve solenoid is typically located near the engine, mounted on or near the intake manifold. It is connected to the evaporative emissions system and the fuel tank. To access it, you may need to remove other components or covers, depending on the specific engine configuration. Always consult the vehicle's service manual for precise location details and removal instructions.
To replace the solenoid on a Cutlass Sierra, first disconnect the battery to ensure safety. Locate the solenoid, which is typically mounted on the starter or nearby on the firewall. Remove the electrical connections and the mounting bolts, then replace it with the new solenoid, securing it in place and reconnecting the wires. Finally, reconnect the battery and test to ensure proper operation.
Yes, Gmc sierra Cruise Control Lever. ?
That would be inside the polar control unit
reverse gear does not work off a solenoid do you have 2nd and 4th gear or just rev missing