answersLogoWhite

0

My guess would be speaker wire.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you fix an electric baseboard heater?

first of all you buy a double pole unit thermostat which should come with the mounting plate and thermostat and it should have 4 wires 2 red 2 black okay now you join the red to the red power wire and black to the black power wire and the 2 remaining wires which should be a red and black can be joined to the red and black wires on your heater .....now you should be good to go ............LEE48


Why is the door warning light on in your Ford Focus?

Bad switch, somewhere, OR... a dorr is ajar. The Trunk Switch has a real problem with the Focus in that it is does not fully close due to dirt or corrosion. Suggest Synthetic grease with a brush all over the sliding parts. You will see 2 wires Black and Red leading to the Latch of the Trunk and these are the wires that the Alarm and Warning Light sense from. You might also have a problem with opening the trunk due to the same problem. Hope this helps.


Changing a car alarm siren?

there is 2 wires one should be red to alarm and black to ground.


Where does the red wire in a baseboard heater connect to the black or white wire in the wall?

In the heater you will have two wires. You should then have 2 supply wires from the panel, and 2 wires from the thermostat. The neutral (white) supply wire should go to one of the wires on the heater. The hot (black) supply wire should connect to one wire from the thermostat. The other wire from the thermostat will connect to the other wire from the heater.


How do you hook the 4 wires which are 2 whites 1 red and 1 black coming from the back of a generator to an outlet for 120v and 240v?

The whites are Neutrals or Grounds and the Red and Black are each 120v. One white and either the black or red for 120v and one white, both the red and black for 240v.


Can red and black be mixed up when wiring or are they interchangeable such as when wiring a range?

A person uses RED and BLACK to identify 2 hot wires. They are in essence 2 different circuits controlling the same device (range in your case). They are interchangeable YES.


1995 Toyota Avalon Looking for iat sensor wires What color are they?

on avalon's with 2 in one mass air flo/air intake temp.. wires are taged in code and color RED= E2 GREEN= THA BLACK/RED= VG BROWN= E2G BLACK/BLUE= +B


How do you install a doorbell with four wires both having black and red wires?

It depends on what the wires are connected to and where the power supply is located. If the switch is lighted power has to get to the switch for the light. With a lighted switch you have a hot supply side, a neutral and then the wire going to the bell. So if Black 1 and Red 1 are supply voltage you would connect Red 1 to the hot side of switch, Black 1 would go to common as would Black 2. Red 2 would go to Bell side of the switch.


Trying to install an IKEA light The light has black white and 2 yellow and green striped wires Ceiling box has 2 black 2 red and white wire Room has 2 switches What should connect to what?

Connect the black wire from the ceiling box to the black wire on the light. Connect the white wire from the ceiling box to the white wire on the light. The yellow and green striped wires from the light are likely the ground wires, secure these to the green or bare copper wire in the ceiling box. Cap off or tape the red wires from the ceiling box, as they are likely for a separate function and are not needed for the light fixture.


How do you reverse the direction your electric cooling fans run there are 3 wires 2 red one black?

Rewiring an electronic fan to change the direction of the fan blade you should take the fan to an electrician. You can attempt to swap the black and red wire but any changes with wires can be dangerous and should be done by a professional.


How do you fix car speakers?

there will be 2 wires one black and one red so jst connect them to your music system and enjoy listening to songs


How do you connect a 1964 Thunderbird radio?

There are two cable connectors. One will have two wires with blue/red strip and black wire. The black wire is the 12 volt power source and the blue/red strip is for the internal radio back light. The other connector may consist of either 2 wires or 4 wires depending on if the car has the optional rear speaker. These wires are black with a green strip. The only other connection is the antenna lead which plugs into the rear of the radio.