electrical resistance
Ampere is a measurement of electrical energy power flow Ohms is the measurement of resistance to flow of energy
5 ohms.
SI Units: Ohms Linesh Chungath India
it depends on the length and width of the wire
ohms laws
ohms
They're are not related. Watts are measurement of power while Ohms are measurement of resistance. One watt equals one volt times one amp.
the answer is ohms
ohms is a measure of resistance(R) in a circuit. Watts is a measure of the power(P), in this case lets assume it is the power used by the resistive element (lamp, heater etc). Power(watts)=Current(Amps)x Current(amps) x Resistance(ohms) or Resistance (ohms)=Power(W)/(current x current)
Resistance, measured in Ohms.
The ohm is the SI unit of measurement for resistance, impedance, and reactance.
A short circuit is an unexpected path of zero resistance between two nodes in a circuit. If you measure the resistance of a resistor, and find that is has zero ohms, but the resistor is supposed to be somthing else, such as 100 ohms, then you can conclude that the resistor is shorted. Keep in mind that the precision of the measurement might be critical. If the resistor is supposed to be 100 ohms, but you get zero ohms, then the answer is easy. If the resistor is 0.001 ohms, but you get zero ohms, then you have to consider the precision of the measurement, the resistance of the wires, etc.
The unit of measurement for inductive reactance (XL) is the ohm.
Ampere is a measurement of electrical energy power flow Ohms is the measurement of resistance to flow of energy
An ohmmeter measures ohms. These are the measurement of electrical resistance. The symbol for ohms is the capital Omega symbol, a symbol that resembles an upside down horseshoe.
First of all, let's get the units of measurement correct, which are kilohms (not 'kil ohms'), megohms(not 'magha ohms'), milliohms, and picohms(not 'pico ohms').Resistors are generally rated in ohms, kilohms, and megohms because, generally, these are the values most widely needed in practical applications.
If you are testing with an ohm meter, it should be near 0 ohms.