answersLogoWhite

0


Best Answer

Field coils and armature

User Avatar

Foreign Que Foreign ...

Lvl 2
2y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are The brushes on an alternator are used to transfer electrical power between what parts?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the alternator brushes on a 1994 Chevrolet Camaro 3.4L?

It would be best to remove the alternator and take it to an electrical shop.


The brushes on an alternator carry?

The brushes on an alternator carry current.


What is the function of the brush holder in the alternator?

The brush holder in an alternator keeps the brushes held to slip rings with spring pressure (or commutators in generators or some motors) which provide electrical contact to electromagnets in the spinning rotor. By varying the electrical current through the brushes to the rotor magnets, you can adjust the power output of the alternator as needed.


Why do your lights dim on your 1999 cougar when im drivin down the road?

There may be a drain on the electrical charging system.First place to look would be the alternator.Put a tester on to the alternator to see if it is faulty.Check brushes in alternator.


What causes your alternator not to charge?

A bad belt, a bad regulator in the alternator or bad brushes in the alternator.


How do you fix thermo king alt code?

Change alternator or check alternator brushes


What are the components in an alternator?

Stator, armature, rectifier, bearings, brushes,


The fan light brake light and the battery charge light comes on on your dashboard what is it or why?

Is it possibly a broken/missing alternator or serpentine belt? (nope just alternator light) It can also be a failing voltage regulator within the alternator, or a failing alternator itself. It is usually the carbon brushes in the alternator when both lights come on, it indicates a field problem with alternator Brushes are not to hard to change on a toyota, just remove the alternator from car, remove rear cover unscrew the brush holder and rectifier?(they are attached together) and install new brushes... you will need a soldering iron. It is a simple repair and at less than 10$ is more affordable than replacing the alternator. VW and Volvo have removable brush holders that unscrew from back of alternator Gm Ford and Mopar, you may have to split alternator to change brushes, there is often a small hole in back of alternator where you can use a piece of wire to keep brushes compressed when you put alternator back together easy job ... save your money


Is the voltage regulator in the alternator on a 2000 Maxima?

Regulator is mounted on the back of alternator. It is replaceable if you can find parts. Brushes are there also.


What would cause the alternator light to come on and off On a 1989 Buick Skyhawk?

A failing alternator with sticky or worn out brushes.


Why wont my alternator charge on my 1994 Chevy lumina apv with 3800 liter engine?

Have you measured the voltage across the battery with the engine running? It should measure approximately 14v. If not you want to replace your alternator/voltage regulator. Check your shop manual to see if you can open the alternator and replace the brushes. After so many miles the brushes wear down, this is the most frequent cause of alternator failure. there is a fusable link in the line between the battery and the alternator i replaced the battery and alt. but still wouldn't charge track the wire


What is the use of brushes in an electric motor?

Brushes transfer electricity to the commutator which is connected to the winding on the armature. The brushes and commutator form a electrical connection that is good when the brushes are stationary and the commutator is spinning. The commutator on a DC motor is sectioned to power different windings at different times, creating moving field necessairy to pull the armature off a direct current.