Crystals with line defects are thermally unstable as its ethalpy change increases more than its entropy change. This leads to an increased in Gibbs free energy.
Within a crystal there are point defects and line defects; point defects are missing or extra lattice points within the crystal lattice (vacancies or interstitials), line defects may be due to an 'extra' half lattice plane within the crystal. The end of a line defect plane is known as an edge dislocation, screw dislocations occur where part of a crystal is displaced over one lattice direction and is therefore twisted. Dislocation loops can occur where an edge and a screw dislocation intersect.
Any change in the configuration of the lattice of the crystal which causes the crystal structure to deviate from the ideal structure is called a crystal structure. It is of the following types - Point defects Line defects Surface defects volume defects
unstable line
they line up like that because i said to do it
rast ts
A thermally controlled mixing valve is connected between the hot supply line and the return line, tempering the hot supply with the cooler return water.
No you can make some crystals with table salt by making a saturated solution look how to do it on line
Common defects of plastics include warping, cracking, shrinking, and surface blemishes. These defects can occur due to factors such as improper cooling during molding, poor material selection, or inadequate design. Proper processing techniques and quality control measures are essential to minimize these defects.
Broiler chickens are highly line bred. Heat defects are the most common. Some have the incorrect number of toes. They are also prone to intestinal deformities.
The restoration mechanisms in metals are either dynamic recovery or dynamic recrystallization. These help to modify the microstructure by arranging line defects (dislocations) into surface defects (boundaries) thus ineffect reducing their spacing, and refining the microstructure.
It may be that the nylon is to smooth to provide a platform for the crystals to form.
No, the motor has to be connected to the line voltage through a set of fuses and then an electrical contactor. Also the motor must be thermally protected against overloads by using an overload block or heaters. This is to allow the motor contactor to drop out is a overload fault should occur.