An input force is what force you act upon a machine. The output is what it does for you in return.
The conversion gain, G, is one of the standard values usually measured and quoted to indicate the performance of a heterodyne or superheterodyne receiver system. G is called a 'gain' because it is a ratio of an output power to an input power. In most practical cases the actual output power is smaller than the input, so it would be more honest to call it a loss Despite this, the convention is to call it a gain, even if it is a gain of -10dB's, the output is ten times smaller than the input. It is called a 'conversion' gain because it indicates the relative level of an output which has been converted to a frequency which differs from that of the input.
use global mapper>coordinate converter> then select input coordinate system and output coordinate system. make sure you pay close attention to datum, zone, greenwhich meridian value etc. Alternatively you can write a matlab program that reads from input excel/notepad file and converts it to desired coordinate based on the preset transformation parameters
the forces that affect trading in global markets are sociocultural forces, economic and financial forces, legal and regulatory forces, and physical and environmental forces.
False forces that are equal in size but opposite in direction are called balanced forces. Unbalanced forces acting on an object cause the object to accelerate.
Like Parallel forces are the forces that are parallel to each other and have same direction. Unlike parallel forces are the forces that are parallel but have directions opposite to each other.
An output force is the force that is exerted from the input force to create motion of the resisting object. the input force can be less or more then the output force
its like a input or output
The applied force to the end of the handle is the input force and the output force is when the broom sweeps over the floor.
levers are classified by the locations of the input and output forces relatively to the fulcrum
The ratio of the output to input forces may help you there.
The applied force to the end of the handle is the input force and the output force is when the broom sweeps over the floor.
Every real machine is subject to forces that reduce output. These include actual forces such as friction, or human controlled forces such as imperfect machining. This reduces the output to less than the ideal.
is an omr and input or output device?
Every real machine is subject to forces that reduce output. These include actual forces such as friction, or human controlled forces such as imperfect machining. This reduces the output to less than the ideal.
Every real machine is subject to forces that reduce output. These include actual forces such as friction, or human controlled forces such as imperfect machining. This reduces the output to less than the ideal.
both input r output
Input device.