The line of force or Flux between a north and south pole of a magnet are cut by rotating conductors. This induces a voltage into the conductors. This is referred to as electromagnetic induction.
When lines of force are cut by a conductor you have electromagnetic induction. A metallic wire can be used as the conductor.
Wire.
When magnetic flux lines of force are cut by induced voltage between magnetic and electric currents. Electromagnetic induction is created.
when lines of force are cut by a conductor we have
Presumably, you are asking what happens when a conductor 'cuts' lines of magnetic flux? If so, then a voltage is induced across the ends of that conductor.
They are lines that cut through parallel lines
no it is just like the intersection of two electric lines or magnetic lines of force tangent gives the direction of flow .At the point of crossing the flow will have two direction
Not the freon lines.
cut or be disconnected.. electromagnetic interference
I think the best material is ferromagnetic material , because in case of ferromagnetic material maximum number of magnetic lines of force pass through it. We know generator works on Faraday's principal of electromagnets. If the maximum no. of lines of force pass through it then when it rotate it cut maximum lines and produce better e.m.f .
Either cut along three non-intersecting lines or two intersecting lines. The lines need not be straight.
Then the two lines cut through by transversal line are parallel to each other.