www (world wide web)
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
NB = inside diameter of the tube. OD = outside diameter of the tube.
89mm
The primary difference between pipe and tubing is how the size is designated. Pipe is designated by a "Nominal Pipe Size" based upon the ID (inside diameter) of the most common wall thickness. Tubing is designated by the measured OD (outside diameter). For Example: A 3/4 inch iron pipe has an OD of 1.050 inches, while a 3/4 inch steel tube has an OD of 0.75 inches. The Copper industry calls all cooper tubular products "Tubes" but they designate a "Type". Each type has specified OD and ID dimensions The size of a tube is determined by it's OD and the thickness. The actual OD of a tube is just the same as it's nominal OD. A certain size of a tube will keep the same OD no mater what the thickness is. It is true for pipe except that the actual OD is larger than it's nominal OD. For example, for a 1" schedule 5s pipe, the actual OD is 1.315", the thickness is 0.065" and the ID is 1.185". When it's thickness is schedule xxs (0.358"), then it's ID is reduced to 0.599" while keeping it's OD. Furthermore, the actual OD of a pipe is just the same as it's nominal OD when the size is the same as or larger than 14" per ASME/ANSI B36.10/19 . Consequently, both the size of tube and pipe is measured by it's OD and the thickness. Actually tube is used when we need to transfer heat from its walls and we want this to be happen while in pipes we try to stop the heat transfer such as we use tubes in boilers because we make steam we need to transfer the heat while when we transport steam we use pipes because we wana save heat energy. 2: pipe can be thick according to formula d/t >10 while tube will must thin according to this formula. The Real Difference: Sorry to say; wrong! Pipe and tube is ever so simple. Pipes are used to transport something, and tubes to construct something; hence, tubes are defined by the od "outside diamater" and wt "wall thickness" (for construction stability), and pipes id inside diamater to allow a calculation for transportation viz., speed, volumes etc. (od = id + 2 * wt).
Yes it has, it is on the first help page, page one.
get your transmission services soon
Nek' je od srca was created in 1999.
The first and most often reason is that the OD is turned off.
OD is disabled.OD is disabled.
on the side of the shifter there is a od button
Just put the gear shifter into od and go.Just put the gear shifter into od and go.
Magic Gas!
gas
Here's a whole page with inventions starting with the letter "D": http://inventors.about.com/od/dstartinventions/a/Inventions_D.htm
OD stands for Over Drive and it just means that your car is adjusting its actions to save money and gas.
Leave OD on during regular condition driving to conserve fuel economy. Turn off OD to accelerate better and when climbing hills.
Benjamin Franklin discovered and introduced electricity to the USA. He also had many other inventions such the wood stove.