An overloaded circuit is an electric circuit that is carrying more current than it is designed to handle, creating a danger of fire through overheating. This often occurs when too many appliances are connected to a circuit at one time.
This answer pertains to overload contacts associated with motor starting equipment. They are three sets of normally closed contacts that are in series with the magnetic contactor coil. Each set is associated with each phase leg that goes to the load. If any of the three load legs gets into an overload condition the trip mechanism for that leg will open the normally closed contact. On opening of these N.C. contacts the magnetic contactor coil will de-energize and the contactor will open thereby disconnect the source voltage to the motor.
A circuit breaker or a fuse.
A circuit breaker has a small handle that will flip to the open position due to overload.
Creates an open circuit in the event that the circuit becomes overloaded. It's a protection feature, preventing melting wires, damage to electrical components, and fires.
Overloaded circuit, short in circuit, or defective switch.
There are two conditions that would cause a breaker to trip off. One is an overload of the circuit and the other is a short circuit on the circuit. The heating element within the breaker is what monitors for circuit overloads.
A dead short to ground or an overloaded circuit.A dead short to ground or an overloaded circuit.
Short in the circuit or the circuit was overloaded.
A circuit breaker or a fuse.
That circuit is overloaded. Call an electrician to fix it for you.
Short in circuit wiring or circuit overloaded.
A circuit breaker/fuse is designed to protect the wiring from getting overloaded.
to prevent a circuit from overloading if too much current flow safely interrupt the circuit if it becomes overloaded
The thing that prevents an overload is the fuse.
the circuit is broken.
Find out why the fuse is blowing. You have a short or the circuit is overloaded.
Circuit breaker or fuse.fuse
If a fuse blows you probably have a short or the circuit is overloaded.