Short in the circuit or the circuit was overloaded.
there is not a proper grounding wire mounted to the body of the car or truck.
Something is shorted to ground on that circuit
what is the best way to melt copper wire?
Moisture causing corrosion on the nutted wires causing a high resistance on the splice which in turn creates heat. Sometimes on conditions like this the wire insulation can melt back up to six inches. Close to the splice the insulation can actually get so brittle that it will fall off of the wire.
A positive wire is grounded out to the frame someplace on the car. Best take it to someone else to get it fixed.
Each size of wire is rated for a specific amount of current that can safely pass through it. If large amperage capacities were to pass through a small size wire, the amperage would create heat and the wire would melt.
You melt the metal and pour it into a thin mold the size of the wire you want.
No, Plastic is not conductive! I other words plastic can not conduct electricity therefore it can not produce resistance, and resistance is what you need to produce heat. and that heat would melt the plastic. Now if you touch a "live" wire to metal and that metal was grounded ( for example to a cold water pipe) then you would be completing the circuit, then that piece of metal would heat up very rapidly and eventually melt! of-course the smart person would not do this but if you where not so smart be prepared to get burned!!!! BE SMART!!
Yes. They melt it down and recycle it.
Well, I am also doing this same question and its all about resistance. Resistance is when the electrons flow around a circuit and they collide with ions. These electrons transfer energy to the ions, which consequently get hot and move more so the resistance increases :) So the thicker the wire is, the less resistance it would have because there are more choices of pathways for the electrons can take without colliding with the ions. Therefore less resistance, more current needed to melt the wire. So the thicker the wire is, the more current is needed to melt it
Fusing current for a wire is the current at which the wire will act like a fuse (melt).
The wire will heat up and melt and the battery may be damged.